Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Fishman Loudbox Mini Charge
Summary of Contents for Fishman Loudbox Mini Charge
- Page 1 USER GUIDE LOUDBOX MINI CHARGE...
-
Page 2: Important Safety Instructions
WARNING: The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION: Danger of explosion if battery is incorrectly replaced. To replace battery use Fishman’s approved battery kit only at Certified Service Centers No naked flame sources, such as lighted candles, should be placed on the apparatus. - Page 3 – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. Changes and modifications not expressly approved by FISHMAN TRANSDUCERS can void your authority to operate this equipment under Federal Communications Commissions rules.
- Page 4 EU Declaration of Conformity CE: Hereby, Fishman declares that this Loudbox Mini Charge is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU, 2014/30/EU, 2014/35/EU. This device complies with Industry Canada license-exempt RSS standard(s): Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference that may cause undesired operation of the device.
- Page 5 Welcome Thank you for making Fishman a part of your acoustic experience. We are proud to offer the fi nest acoustic amplifi cation products available; high-quality professional-grade tools which empower you to sound your very best.
-
Page 6: Getting Started
AC adapter into the back of the amplifi er and the provided line cord into the AC adapter. 2. Plug the Loudbox Mini Charge line cord into an electrical outlet with the ap- propriate AC voltage, 100-240VAC 50/60 Hz. -
Page 7: Front Panel
Front Panel 1. Instrument Input This 1/4” input accepts all types of passive or active acoustic pickups. 2. Phase Use the Phase switch to improve bass at low volume and suppress feedback at high volumes. 3. Gain Use the Gain knob to set the signal level for the instrument input. 4. -
Page 8: Mic Input
Controls the amount of digital reverb in the Microphone channel. 14. Master Volume Set the overall level of the Loudbox Mini Charge with the Master Volume. In general, put the Master Volume as high as possible using less Gain (2 o’clock to 5 o’clock) to achieve the cleanest sound. -
Page 9: Bluetooth ® Indicator
Front Panel (cont.) 16. Bluetooth Indicator ® This green indicator will display a medium fl ash indicating the Bluetooth mod- ® ule is ready for pairing. It will display a slow fl ash indicating the module is ready for reconnection with a previously paired device. The indicator will be on when playback is active and display a fast fl... - Page 10 Front Panel (cont.) 18. Green Battery Indicator When on, this green indicator tells you that the battery is charged, functional and power is available. 19. Red Low Battery Indicator When on, this red indicator denotes that the battery’s available charge is low. All indicators will turn off and the amplifi...
-
Page 11: Rear Panel
Rear Panel 1. DC In Operate the amplifi er only at the voltage indicated on the rear panel. Plug in the supplied DC cable into the DC In power socket on the amp. Plug the provided AC cable with the female IEC-style 320 connector into the AC Adapter and the male AC plug appropriate for your region into an outlet. -
Page 12: Low Volume
Begin at a very low volume and work your way up. As you turn up, try adjusting the Loudbox Mini Charge’s tone controls as recommended below. 1. Low volume At a low volume (just above conversation level) our ears are not very sensitive to bass and treble, so give the Low and High controls a good boost. -
Page 13: Block Diagram
Block Diagram Instrument Class-A Hi-pass Gain Low, High Middle Phase Input Buffer Filter Mix D.I. Output (mic level) Master Power Instrument Instrument Limiter Crossover Volume Amplifier Chorus Reverb Level Chorus In Digital Tweeter Effects Reverb In Reverb Level Woofer Hi-Pass Gain Low, High Input... -
Page 14: Technical Specifications
Technical Specifi cations Ratings applicable to internal battery or external power source Output rating: SPL @ 1 meter 108 dB (measured) Frequency Response 80 Hz – 20 kHz Power rating: 60 W Battery: Est. Performance Times 18 hours (low volume) 12 hours (average volume) 4 hours (full volume) Charge Time... - Page 16 Fishman and Fishman Transducers are trademarks or tradenames of Fishman Transducers Inc. 513-300-271 Rev 1...
Need help?
Do you have a question about the Loudbox Mini Charge and is the answer not in the manual?
Questions and answers
How can I best prevent feedback from an acoustic guitar and vocals in the first place when using the Loudbox?
The provided context does not explicitly mention how to prevent feedback when using the Fishman Loudbox Mini Charge. However, in general, feedback can be minimized by:
1. Positioning the amp correctly—keeping it in front of the microphone and guitar to avoid direct sound loop.
2. Lowering the volume or gain if feedback occurs.
3. Using the amp's EQ settings to reduce frequencies prone to feedback (typically mid or high frequencies).
4. Avoiding excessive reverb or effects that might amplify feedback.
5. Using a soundhole cover on the guitar to reduce resonance.
If specific feedback prevention features exist on this amp, they are not mentioned in the provided context.
This answer is automatically generated
my amplifier does not light up any of the charging lights to the right
The charging indicator on the Fishman Loudbox Mini Charge amplifier does not light up if the AC adapter is not connected or receiving power, or if the battery is fully charged.
This answer is automatically generated