Incorrect Routing Information - HP 3600 v2 series Configuration Manual

Display OSPF interface information using the display ospf interface command.
2.
Ping the neighbor router's IP address to check connectivity.
3.
Check OSPF timers. The dead interval on an interface must be at least four times the hello interval.
4.
On an NBMA network, using the peer ip-address command to specify the neighbor manually is
5.
required.
On an NBMA or a broadcast network, at least one connected interface must have a router priority
6.
higher than 0.

Incorrect routing information

Symptom
OSPF cannot find routes to other areas.
Analysis
The backbone area must maintain connectivity to all other areas. If a router connects to more than one
area, at least one area must be connected to the backbone. The backbone cannot be configured as a
Stub area.
In a Stub area, all routers cannot receive external routes, and all interfaces connected to the Stub area
must belong to the Stub area.
Solution
Use the display ospf peer command to display neighbors.
1.
Use the display ospf interface command to display OSPF interface information.
2.
Use the display ospf lsdb command to display the LSDB to check its integrity.
3.
Display information about area configuration using the display current-configuration
4.
configuration ospf command. If more than two areas are configured, at least one area is
connected to the backbone.
In a Stub area, all routers attached are configured with the stub command. In an NSSA area, all
5.
routers attached are configured with the nssa command.
If a virtual link is configured, use the display ospf vlink command to check the state of the virtual
6.
link.
129