Show Cdp Neighbors - Cisco Nexus 5500 Series Command Reference Manual

Chapter Show Commands

show cdp neighbors

To display the Cisco Discovery Protocol (CDP) neighbors, use the show cdp neighbors command.
Syntax Description
interface
ethernet
slot/[QSFP-module/]port
mgmt mgmt-num
detail
Command Default
None
Command Modes EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Examples This example shows how to display all CDP neighbors:
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
Device-ID
sw-sw70
switch(FOC16333ZER)
switch(FOC16333ZER)
switch(FOC16333ZER)
switch(FOC16333ZER)
switch#
This example shows how to display the CDP neighbors for a specific Ethernet interface:
OL-27880-02
show cdp neighbors [interface {ethernet slot/[QSFP-module/]port | mgmt mgmt-num}] [detail]
(Optional) Displays CDP neighbor information for an interface, Ethernet
or management.
(Optional) Displays CDP neighbor information for an Ethernet interface.
The slot number is from 1 to 255. The QSFP-module number is from 1
to 4. The port number is from 1 to 128.
Note
(Optional) Displays CDP neighbor information for a management
interface. The management interface number is 0.
(Optional) Displays the detailed information about CDP neighbors.
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Local Intrfce Hldtme Capability
mgmt0
Eth1/4
Eth1/6
Eth1/10
Eth1/12
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
145 S I WS-C3560E-48T Gig0/30
169 S I s N6K-C6004-96Q Eth1/12
173 S I s N6K-C6004-96Q Eth1/10
175 S I s N6K-C6004-96Q Eth1/6
169 S I s N6K-C6004-96Q Eth1/4
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
show cdp neighbors
Platform Port ID
1271