Huawei SVN5630 Quick Start Manual

HUAWEI SVN5630/5660/5830/5850
V200R003
Quick Start
Issue: 02
Part Number: 31507272
Date: 2015-06-18
Thank you for using Huawei SVN5630/5660/5830/5850 products. This product can serve as a remote access gateway to
provide low-cost SSL VPN services. This document describes the appearance, cabling, and network and basic SSL VPN
configurations of the device. For detailed hardware description and installation guidelines, refer to the
detailed configurations, refer to the
Safety Precautions
Be aware of the following safety precautions when installing the device.
• Deactivate power whenever possible before performing maintenance on power cables.
• Always wear a properly-grounded wrist strap before touching the device or expansion cards in it.
Device and Accessories
Your product package includes the following items:
SM-HDD-SAS300G-B
Rear panel
Equipment
Serial Number
Management
port
10/100/1000M autosensing
Ethernet electrical port
2
0/1
3
SYS PWR MGMT
0 1 2 3 4 5 6 7 8
MGMT
SVN5800
2
0/1 ALM HDD MODE
3
1
0
RST
CONSOLE
ESD jack Console port
4x1GE SFP
The figure above uses the SVN5660/5830/5850 as an example. The fixed interface board on the front panel provides 8
10/100/1000M autosensing Ethernet electrical ports, 4 GE optical ports, and 2 USB ports. The power module on the rear pan-
el is removable. For the SVN5630, the fixed interface board on the front panel provides 6 service ports (4 GE electrical ports
and 2 combo ports) and 1 USB port, and the power module on the rear panel is non-removable.
AC power cables vary by country or area, and the AC power cable in the figure is used for reference only.
Cabling
• One-armed mode: Connect the device to a router or firewall out-of-path. This mode requires fewer
ports and does not change existing network topology.
1. Connect the ground terminal on the device to the ground bar using a PGND cable.
2. Connect port GE1/0/4, for example, to a router or firewall.
3. Connect the device's MGMT port to a PC where the NMS client is installed using a network cable.
4. Insert the cable retention clip into the hole close to the power socket. Then insert the power cable into the socket, and fix
it using the clip.
Administrator Guide
Power socket
4 HDD
INPUT OUTPUT
ON
XXXXXXXXXXXXXXXXXXXXXXXXXXX
OFF ~100-240V;50/60Hz;2.5A
Protection ground
terminal
WSIC(Slot 2)
9 10 11
WSIC(Slot 3)
Front panel
.
5 PWR 6 PWR
SVN5800
4 HDD 5 PWR 6 PWR
Rack-mounting ears
M4
screw
AC power cable
Copyright © Huawei Technologies Co., Ltd. 2015. All rights reserved.
1
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
Hardware Guide
. For
Rubber feet Quick start
M6 Power cable
screw retention clip
PGND cable