Sealy Reflexion-UP Foundation Installation page 4

STEP 7
If this delivery involves dual foundations and/or
split mattresses, see instructions for joining two
foundations on page 15.
STEP 8
Carefully ip the Re exion
the topside up position.
NOTE: Make sure to lift the foundation(s) off the
ground before fl ipping over. DO NOT use legs as
a leverage point to ensure they do not break.
ATTENTION !
!
DO NOT
lean the bed against the
installed legs to flip it over.
STEP 9
Route the control box cable to your preferred side of
the bed.
STEP 10
Install the Mattress Retainer Bar (C).
STEP 10A
Remove Mattress Retainer Bar (C) from frame.
STEP 10B
Unscrew Retainer Bar Plate (D) and Retainer Bar Screw
(E) from frame with screw driver (not provided).
TEMPUR SEALY CUSTOMER SERVICE DEPARTMENT: 1–800–499–1965
14
® -UP Foundation(s) over to
Improper handling
Reflexion
STEP 10C
Install Mattress Retainer Bar (C) and replace Retainer
Bar Plate (D).
STEP 10D
Tighten Retainer Bar Screw (E) with screw driver.
STEP 11
Place the mattress(es) on the foundation(s).
WARNING: When placing the foundation(s)
within a bed frame, verify the space between
the headboard cross member and the top of the
mattress is no more than 3 inches.
STEP 12
Ensure the power switch on the surge protector is in
the "on" position and that it is plugged into the wall
outlet. Check the system for functionality with the
mattress in place.
® -UP Foundation