Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for E-fly 100C
Summary of Contents for E-fly 100C
- Page 1 LCD DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Opertating Manual...
-
Page 2: Table Of Contents
Catalog Function of Transmitter Contents Specifications Notice for flying Notification before Using Description of four flying modes Transmitter particular introduce Other function of transmitter Receiver Electrio speed controler Operation for transmitter and servo Adjustmen order Charge method of battery Explaination for Technical words www.art-tech.com... -
Page 3: Function Of Transmitter
Thanks for purchasing E-Fly 100C radio control set. For safe use, please read this manual before using carefully. Any damage or loss to radio control set and model due to inproper usew ill n ot b e shouldered by Art-Tech. -
Page 4: Notice For Flying
Notice for flying Please do not fly in the rain or strong wind. The water can sink into the transmitter which can cause out of control,leading to crash. T h e s h o r t e n e d a n t e n n a m a y c a u s e t h e s h o r t range. -
Page 5: Notification Before Using
Notification before Using Indications of Special signs Please pay more attention to signs in this manual and safety while using Show Logo Meanings I Inproper operation may cause injury or hurt WARNING I Inproper operation may cause injury or hurt CAUTION Storage note ▲Please do not place the radio control set in the below situation:... -
Page 6: Description Of Four Flying Modes
Description of four flying modes ETC61-2.4GHz with four flying mode installed:A(aeroplane mode); V(V tail mode);C (CCPM h elicopter m ode); H(helicopter mode) The swithc between each mode is very convenient. There is a reverse switch for Ch1, CH2,CH4 and CH6 separately.The LCD on the transmitter can show voltage o f transmitter, chann el status, flying mode and flying time.It has a function of auto-alarm for low voltage. -
Page 7: Transmitter Particular Introduce
Transmitter particular introduce A：Antenna L：Tiny Mix for Channels B：LCD(Liquid Crystal Display) 1）If the transmitter is Mode 1,it is for Ch3 1）To indicate the battery voltage of transmitter 2）If the transmitter is Mode 2,it is for Ch1 2）To show the situation of channels whether it is M：Tiny Mix for Channels reversed 1）If the transmitter is Mode 1,it is for Ch1... -
Page 8: Other Function Of Transmitter
Other function of transmitter Alarm for low voltage of transmitter When the voltage of transmitter battery is under working voltage, the red LED will flash.It is better to stop flying,or that can cause crash of model. Switch for servo reverse operation During using, if servos movement can not cater to the model`s flying need, the servos movement can be changed.CH1 is for ailoren, ch2 for elevator,ch3 for motor, and ch4 for rudder. -
Page 9: Receiver
Receiver Specifications Operating voltage ：4.8V~5.2V Current drain： ≤40mA Weight：12g dimension：44mm*23mm*15mm Channels: 6 Channels Reception system： GFSK Range(Height)： ≥350m Adjacent channel rejection： ≥-85dBm± 16kHz Function For operating helicopter Operation for aeroplane 襟翼 Pitch Undercarriage Gyro gain Rudder Rudder Throttle Throttle Elevator Elevator Aileron Aileron... -
Page 10: Electrio Speed Controler
Electrio speed controler Specifications for ESC-30A Working currency:30A/50A(max currency） input voltage：DC,5V-14.4V. starting mode：adaptable point（1.0ms-1.5ms） control mode：200 class proportional output voltage(BEC) ：5V/1A(direct for servo ) To batte ry To moto r To receiv er To batte ry Auto cut-off function When the voltage of battery in model plane is under working voltage, ESC has the function of cutting the power to the motor and only supply to receiver in order to save power. -
Page 11: Operation For Transmitter And Servo
Operation for transmitter and servo For operating helicopter (Mode 1) Before adjusting, please be familiar with transmitter operation and servo(Below description in case of all neutral) Ailoren Operation Joystick for ailoren left forward plane moves left Joystick for ailoren right forward plane moves right Elevator Operation Joystick for elevator up forward... - Page 12 Operation for transmitter and servo Operation for aeroplane (Mode 1) Before adjusting, please be familiar with transmitter operation and servo(Below description in case of all neutral) Ailoren Operation Joystick for ailoren righ forward the right ailoren up and left ailoren downand vice versa Elevator Operation Climb upforward Operation...
-
Page 13: Adjustmen Order
Adjustmen order Open the battery bay, and range the 8 cells AAA battery into the battery bay, then close the bay.Before adjustment, change the reverse switch to the lower positon(Nor). Open the transmitterand the receiver, and do the following steps: 1.check every servo`s movement and make sure every movement of control arms and servo arms is correct If not, please change the switch for reverse. -
Page 14: Explaination For Technical Words
Explaination for Technical words Here are some technical words used in this Manual Aileron:Either of two movable flaps on the wings of an airplane that can be used to control the plane's rolling and banking movements Elevator:A movable control surface, usually attached to the horizontal stabilizer of an aircraft, that is used to produce motion up or down. - Page 15 There will be no notice while changes caused by improving. Without permitting,it is forbidden to do copy of the content of this manual. www.art-tech.com...
Need help?
Do you have a question about the 100C and is the answer not in the manual?
Questions and answers