Software Recovery On Icx 6430, Icx 6450, Icx 6650, Icx 7450, Icx 7750, And Fsx Devices - Brocade Communications Systems FastIron X Series Software Update

8. Copy the image from the TFTP server to the primary and secondary flash partition using the copy
tftp flash ip-address image-file-name primary | secondary command; for example:
copy tftp flash 192.168.1.200 FCXR08000.bin primary
9. Enter the show flash command to check whether the image copy process was successful.
10. R eboot the device using the reload command.
Software recovery on ICX 6430, ICX 6450, ICX 6650, ICX 7450, ICX
7750, and FSX devices
NOTE
In practice, the TFTP server is also used as the terminal server to see the CLI output.
1. Connect a console cable from the console port to the terminal server.
2. Connect an Ethernet cable from the management port (the port located under the console port on the
device) to the TFTP server.
3. On the TFTP server, assign an IP address to the connected NIC; for example, IP address
10.10.10.21 mask 255.255.255.0.
4. Reboot the device, and go to the boot monitor mode by pressing "b".
5. When in boot mode, enter the printenv command to display details of the images available on the
device memory; for example:
ICX64XX-boot> printenv
baudrate=9600
uboot=/foundry/FGS/bootcode/kxz07400.bin
ver=07.4.00T310 (Mar
6. Provide the IP address of the TFTP server that hosts a valid software image using the setenv
serverip command; for example:
ICX64XX-boot> setenv serverip 10.10.10.21
7. Set the IP address, gateway IP address, and netmask for the device management port, and save the
configuration using the setenv ipaddr, setenv gatewayip, setenv netmask, and saveenv
commands; for example:
ICX64XX-boot> setenv ipaddr 10.10.10.22
ICX64XX-boot> setenv gatewayip 10.10.10.1
ICX64XX-boot> setenv netmask 255.255.255.0
ICX64XX-boot> saveenv
NOTE
The IP address and the gateway IP address set for the device management port should be for the
same subnet as the TFTP server NIC.
8. Enter the printenv command to verify the IP addresses that you configured for the device and the
TFTP server; for example:
ICX64XX-boot> printenv
baudrate=9600
ipaddr=10.10.10.22
gatewayip=10.10.10.1
netmask=255.255.255.0
serverip=10.10.10.1
uboot=/foundry/FGS/bootcode/kxz07400.bin
ver=07.4.00T310 (Mar
FastIron Ethernet Switch Software Upgrade Guide
53-1003632-02

Software recovery on ICX 6430, ICX 6450, ICX 6650, ICX 7450, ICX 7750, and FSX devices

SW: Version 08.0.00acT5 Copyright (c) 1996-2004 Foundry Networks, Inc.
Compiled on Apr 06 2013 at 20:13:29 labeled as FCXR08000
(2949675 bytes) from Tftp
1 2012 - 11:28:23)
1 2012 - 11:28:23)
35