To do...
Display detailed information
about a specific or all
aggregation groups
Clear LACP statistics for a specific
or all link aggregation member
ports
Clear statistics for a specific or all
aggregate interfaces
Ethernet link aggregation configuration examples
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
"Configuration
sure that all member ports have the same port attributes and class-two configurations as the reference port.
The other settings only need to be configured on the aggregate interface, not on the member ports.
Layer 2 static aggregation configuration example
Network requirements
As shown in
•
Router A and Router B are connected through their respective Layer 2 Ethernet interfaces
GigabitEthernet 3/1/1 through GigabitEthernet 3/1/3.
Configure a Layer 2 static aggregation group on Router A and Router B, respectively, and enable
•
VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and
VLAN 20 at one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and
•
destination MAC addresses.
Figure 6 Network diagram for Layer 2 static aggregation
Use the command...
display link-aggregation verbose
[ { bridge-aggregation | route-aggregation }
[ interface-number ] ] [ | { begin | exclude |
include } regular-expression ]
reset lacp statistics [ interface interface-list ]
reset counters interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
classes") as the reference port (see
Figure
6:
"Reference
port") can operate as selected ports. Make
26
Remarks
Available in any
view
Available in user
view
Available in user
view