Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Garaventa Xpress II
Summary of Contents for Garaventa Xpress II
- Page 1 OWNER’S MANUAL Xpress II Inclined Platform Lift...
- Page 3 Congratulations on the purchase of your new Xpress II inclined platform lift. This manual describes the many features of the Xpress II, how to operate it properly and how to per- form simple safety and maintenance checks. Please make sure that you read this Manual before operating the lift.
-
Page 5: Table Of Contents
Table of Contents SAFETY FIRST!...................6 DO NOT TRANSPORT FREIGHT................6 DO NOT STAND ON PLATFORM................6 DO NOT PLACE HANDS BEHIND PLATFORM............6 PASSENGER MUST ALWAYS FACE DIRECTION OF TRAVEL........6 DO NOT OVERLOAD THE LIFT ................6 PREVENT PEDESTRIAN CONTACT WITH MOVING PLATFORM .......6 COMPONENT IDENTIFICATION..............7 BASIC OPERATING INSTRUCTIONS............8 ADDITIONAL INSTRUCTIONS FOR OPTIONAL FEATURES......9... -
Page 6: Safety First
The following procedures are very important to ensure the safe operation of your Xpress II. Do Not Transport Freight The lift must never be used for anything but its intended use. -
Page 7: Component Identification
2. Component Identification Wrap around safety arms Platform Control Panel Fold down seat Mains power (optional) breaker switch Boarding ramps with obstruction sensing Upper rail Lower rail - 7 -... -
Page 8: Basic Operating Instructions
3. Basic Operating Instructions Call Station 1. Check to make sure no one else is using the lift. If the lift is already at your land- Attendant Call (Optional) ing, proceed to step 4. 2. If the platform is at the other station, Directional Controls insert your key into the key switch and turn to the “On”... -
Page 9: Additional Instructions For Optional Features
4. Additional Instructions for Optional Features Fold-down Seat for Ambulatory Passengers • To use, fold the seat down and fasten the seat belt before operating the lift. • When exiting the platform, tuck the seat belt back into the holder pro- vided. -
Page 10: Instructions For Emergency Manual Lowering
5. Instructions for Emergency Manual Lowering If the lift stops while occupied, the emergency hand wheel should be used to move the platform to the desired location. To operate the emergency manual lowering system, you may wish to refer to the following illustrations while proceeding with these steps: 1. - Page 11 Note: This strap is to be used only in the event of an emergency! 9. Ensure the mains breaker switch is in the ‘Off’ position. Phone your authorized Garaventa rep- resentative for assistance. Drive Hand Wheel Drive Hand wheel Drive Hand Wheel...
-
Page 12: Scheduled Maintenance
Scheduled Maintenance Agreement. This agreement will ensure that your lift will be properly maintained, and that the life of your Xpress II will be extended. Depending on the length of this agreement, your warranty could be extended up to five years. -
Page 13: Warranty Information
8. Specifications Platform: Platform Size: 800mm x 1250mm (31 ½” x 49 ¼”) 800mm x 1220mm (31 ½” x 48”) 800mm x 1000mm (31 ½” x 39 ⅜”) 750mm x 900mm (29 ½” x 35 ½) Rated load: 225 kg (495 lbs), with a five times safety factor. Speed: Up: 4 meters (13 ft) per minute, Down: 4.9 meters (16 ft) per minute, with a soft-start/stop transition... -
Page 14: Specifications
8. Specifications Over speed Safety: Located on the upper carriage of the platform, containing mechanical over speed sensor and lock, with electrical drive cut-out protection. Finish: Upper and Lower Rail: Champagne anodized aluminum. Hanger: Zinc plated frame within a vacuum formed ABS cover. Platform: Zinc plated frame with mono color powder coated surfaces and cham- pagne anodized ramps and side kick plates. - Page 15 © G a ra v e n t a L i f t . A s w e a r e continuously improving our products, specifications outlined in this brochure are subject to change without notice. Authorized Garaventa Lift Representative www.garaventalift.com...
Need help?
Do you have a question about the Xpress II and is the answer not in the manual?
Questions and answers