Vrf (Dynamic-Template-Bng) - Cisco ASR 9000 Series Command Reference Manual

vrf (dynamic-template-BNG)

vrf (dynamic-template-BNG)
To set the vrf in which the interface operates, use the vrf command in the dynamic template type configuration
mode. To disable the VRF, use the no form of this command.
vrf vrf-name
no vrf
Syntax Description
vrf_name
Command Default
None
Command Modes
Dynamic template type configuration mode
Command History
Release
Release 4.2.0
Usage Guidelines
Use the dynamic-template command to enter dynamic template configuration mode.
Task ID
Task ID
config-services
Examples This is an example of configuring the vrf command in the dynamic template type configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type service s1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# vrf vrf1
Related Commands
Command
dynamic-template, on page 232
dynamic-template type ppp, on page 236
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
248
Specifies the name of the vrf.
Modification
This command was introduced.
Operation
read, write
Description
Enables the dynamic template configuration mode.
Enables the ppp dynamic template type.
Dynamic Template Commands