Additional Information; Dual Ip Configuration; Manage The Dxt-H4; Teradici Administrative Web Interface (Awi) - Amulet Hotkey DXT-H4 User Manual

a
DDItIonal InformatIon

7. Additional information

7.1

Dual IP configuration

The DXT-H4 utilises two IP addresses. One is the address of the
Teradici PCoIP host. The second IP address is for the Amulet
Hotkey Management Interface (MI).
By default the network connection to the MI (and its associated
IP address) are turned off. To turn on this functionality, it is
necessary to enable the second network connection to the MI.
See 7.2.3 for how to do this.
7.2

Manage the DXT-H4

There are two types of management interface for the DXT-H4:
• Teradici Administrative Web Interface
• Amulet Hotkey Management Interface

7.2.1 Teradici Administrative Web Interface (AWI)

Use the AWI to download host firmware for the PCoIP
component of the system and to manage the PCoIP settings.
See 7.3.1 for how to connect with the AWI.
See 7.4.2 for how to check the firmware.
See 7.5.1 for how to download Teradici firmware to the DXT-H4.

7.2.2 Amulet Hotkey Management Interface (MI)

Use the MI to download other firmware components and
configure additional functionality of the DXT-H4.
Examples: To gather system information, for downloading
firmware updates to the system microprocessor and other
system components, or for setting up virtual desktop brokering
such as VMware Horizon.
See 7.2.3 and 7.3.2 for how to connect with the MI.
See 7.4.3 for how to check the firmware.
See 7.5.2 for how to download Amulet Hotkey firmware to the
DXT-H4.
7.2.3 Enable the connection to the Management Interface
To turn on the network connection to the MI:
1. Press and hold the front Fn button and power cycle the unit.
This enables the MI for this power cycle only.
Note: To change the default state so that the Management
Interface is available at every power up, you use configuration
commands. Contact Technical Support for assistance.
Important!
override whatever user configuration is set to.
7.3
There is a login method for each management interface:
(AWI);
•
(MI).
•

7.3.1 To login with the AWI

1. Enter the IP address of the host in the browser window.
Note: You can get this from the DHCP server if you know the
MAC address of the host, or if the IP address has not been
changed, use the default value in 1.3.
The login screen appears.
Figure 22:
Pressing the Fn button on start-up will always

Login to the management interfaces

To login with the AWI;

To login with the Amulet Hotkey Management

Administrative.Web.Interface
www.amulethotkey.com | Page 29
7

Interface.