STEP 1
Reassemble of Device
Tools: Philips screwdriver, spudger, Fingers,
PDI pads.
•
Use a scraping tool to clean the frame of old adhesive and remaining
glass shards. (PDI pads are good for removing adhesive) (area shown by
red arrows).
•
Most new assemblies come with new adhesive so take all plastic tape off
covering the adhesive.
•
Place new assembly on the frame in the correct position. You will want to
test fit the new assembly to the frame reassuring that the Digitizer/LCD
cables fit with the motherboard already attached to back housing.
•
Put motherboard back onto the Plastic frame. I say put new assembly on
as you lay the motherboard back down on frame. It makes the fit easier so
the lcd cable isn't pulling awkwardly through the frame.