Mac-Based Vlan Configuration Commands; Display Mac-Vlan - HP A5830 Series Command Reference Manual

The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports:
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
The local and remote trunk ports must use the same PVID for the traffic of the PVID to be transmitted
properly.
You must use the port trunk permit vlan command to configure the trunk port to allow and forward
packets from the PVID.
Related commands: port link-type and port trunk permit vlan.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameter
vlan-id: Specifies a VLAN ID, in the range of 1 to 4094
Examples
# Configure VLAN 100 as the PVID of the trunk port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk pvid vlan 100
# Configure VLAN 100 as the PVID of the trunk Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk pvid vlan 100

MAC-based VLAN configuration commands

display mac-vlan

Description
Use the display mac-vlan command to display the specified MAC address-to-VLAN entries.
If mac-address mac-address is specified but mask is not specified, only the MAC address-to-VLAN entry
containing the specified MAC address is displayed.
163