Sanyo NVM-4070 Instruction Manual page 16

Using the car Mounting kit
1. Clean and dry the mounting surface with a clean cotton cloth.
2. If the ambient temperature is below +60°F (15°C), you can warm the
mounting area and the suction cup (e.g. with a hair dryer) to ensure a
strong suction bond.
3. Install the car mount on the selected area.
On the Windshield
a. Fix the suction cup to the selected area with the locking lever facing
up for easier access.
b. Flip the locking lever away from you to create a vacuum between the
suction cup and the window surface.
On the Dashboard
Warning: The permanent mounting adhesive is extremely difficult to
remove after it is installed.
a. Remove the backing from the permanent mounting adhesive on the
bottom of the disc and place the mounting disc on the dashboard.
b. Fix the suction cup to top of the mounting disc with the locking lever
facing up for easier access.
c. Flip the locking lever away from you to create a vacuum between the
suction cup and the mounting disc.
Make sure that the suction is strong and stable before proceeding to the
next step.
4. After you are sure the mounting bracket is safe and secure, attach and slide
the NVM-4070 into its ratching plate. It snaps in easily with the quick
release connectors.
5. Adjust the car mount for the best viewing angle.
6. Connect the car adaptor into the cigarette lighter receptacle.
7. The car adaptor LED indicator will glow when powered.
NVM-4070 Portable Navigation System
Contents
8. Plug the car adaptor into the side of the NVM-4070 and position the cord
to an appropriate location.
NOTE: Your car may be required to switch the vehicle ignition into the
accessories position to power the cigarette lighter. Your NVM-4070 will not
charge with the ignition off.
Figure 6: Mounting on the windshield
New Photograph
16
Index
Chapter 2 Getting Started