Ip Device Tracking Maximum - Cisco Catalyst 3650 series Command Reference Manual

ip device tracking maximum

To configure IP device tracking parameters on a Layer 2 access port, use the ip device tracking maximum
command in interface configuration mode. To remove the maximum value, use the no form of the command.
ip device tracking maximum number
no ip device tracking maximum
Syntax Description
number
Command Default
None
Command Modes
Interface configuration mode
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
To remove the maximum value, use the no ip device tracking maximum command.
To disable IP device tracking, use the ip device tracking maximum 0 command.
Note This command enables IPDT wherever its configured
Examples
This example shows how to configure IP device tracking parameters on a Layer 2 access port:
Device# configure terminal
Enter configuration commands, one per line.
Device(config)# ip device tracking
Device(config)# interface gigabitethernet1/0/3
Device(config-if)# switchport mode access
Device(config-if)# switchport access vlan 1
Device(config-if)# ip device tracking maximum 5
Device(config-if)# switchport port-security
Device(config-if)# switchport port-security maximum 5
Device(config-if)# end
Number of bindings created in the IP device tracking table for a port. The range is
0 (disabled) to 65535.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
ip device tracking maximum
Modification
This command was introduced.
End with CNTL/Z.
763