Table of Contents
Advertisement
Dual (Redundant)
Controller
Configuration
This section details the basic information needed to configure the settings of dual
VNM Enterprise Controllers. For information on how to set up a single controller, see
VNM Enterprise Controller Settings Configuration
This section provides information on:
•
•
•
•
•
NOTE:
Setup Overview
1.
2.
3.
4.
5.
6.
7.
8.
9.
Setup Overview
Configuring Dual VNM Enterprise Controllers
Configuring Dual Enterprise Controllers as the System Controller
Configuring VN‑Matrix Devices for Dual VNM Enterprise Controllers
About the Cluster Properties Pages
For additional configuration information, see
Configuration
on page 19. Configure each VNM Enterprise Controller identically.
Use a network switch to connect the primary VN-Matrix network to the rear panel
Ethernet connector (eth0) of each VNM Enterprise Controller (see
on page 9).
Use an RJ-45 crossover cable to connect the VNM Enterprise Controller Ethernet
connectors (eth1) together (see
Power on each VNM Enterprise Controller, all VN-Matrix devices present in the system,
and all necessary devices (see
Connect a control PC to the VN-Matrix network and navigate to the web-based user
interface of each VNM Enterprise Controller (see
Interface
on page 11) .
Configure the settings of each VNM Enterprise Controller (see
VNM Enterprise Controllers
Configure the VNM Enterprise Controller pair to act as the controller for the
VN-Matrix system (see
Configuring Dual Enterprise Controllers as the System
Controller
on page 141).
Configure the devices within the VN-Matrix system (see
Devices for Dual VNM Enterprise Controllers
If necessary, update the license of each VNM Enterprise Controller (see
Firmware and License Updates
Power down each VNM Enterprise Controller and all configured devices (see
Power Down Procedure
VNM Enterprise Controller and all necessary devices.
VNM Enterprise Controller • Dual (Redundant) Controller Configuration
on page 14.
Advanced Controller
figure 2
Rear Panel Features
and
Power Down Procedure
Accessing the Web‑based User
on page 135).
on page 145).
on page 155).
on page 12). After a few seconds, power on each
Single
Rear Panel Features
on page 9).
on page 12).
Configuring Dual
Configuring VN‑Matrix
Controller
134
Advertisement
Table of Contents
