Golden wheel CS-471 Instruction Manual

GOLDEN WHEEL
CS-471
1-NEEDLE,TOP & BOTTOM FEED, LONG CYLINDER BED,
LOCKSTITCH MACHINE FOR EZTRA HEAVY-WEIGHT
MATERIALS WITH A SEMI-ROTARY LARGE-CAPACITY
SHUTTLE
INSTRUCTION MANUAL

BEFORE OPERATION

1. Do not the machine even for trial before lubricating it.
2. Confirm that the voltage and phase (single or 3-phase) are correct by checking them againt the
ratings shown on the nameplate.
3. When running your machine for the first time after the set-up, check the rotational direction of
the handwheel.
・ Turn ON the power switch. Run the machine at a low speed while checking the rotational
direction of the handwheel.(The handwheel should turn counterclockwise as observed from the
handwheel side.)
4. For the first month, run the machine at a speed of 600 s.p.m. or less.

CAUTIONS IN OPERATION

1. Keep your hands away from the needle when you turn ON the power switch or while the machine
is operating.
2. During operation, be careful not to allow your or any other person's head or fingers to come close
to the handwheel, V belt, bobbin winder or moter. Also, do not place anything close to them.
3. Do not run the machine with the finger guard, belt cover or any other protectors removed.
Eye guard is option.
4. Be sure to turn OFF the power switch and confirm that the motor is completely stopped before
removing the V belt.
5. Never remove the sewing machine from the table with the moter removed from the table.

SPECIFICATIONS

Usage
Sewing speed
Stitch length
Lift of presser foot
Thread take-up lever
Needle bar stroke
Pouches, bags, shoes, bag handles,
safty belts, etc.
Max.800s.p.m.
Max.11mm
Hand lifter 12mm
Knee lifter 20mm
Cam-type thread take-up lever
56mm
Please read this Instruction Manual
carefully before using the unit in or
-der to get the most out of it and
to enjoy using it for a long time.
Please keep this Instraction Manual
at hand taking care not to lose it.
Needle to used
Needle system
Thread
Stitch adjusting method
Lubrication method
Motor to be used

1] INSTALLING THE THREAD STAND

Assemble the thread stand, and install it to the right
-hand side of the far side of the table with screws
① (at 3 places).
- 1 -
No.000001
Schmetz 794Nm230
Nm130～Nm280
#00～#8
Lever nut type
Hand oiling
3-phase/single phase 400W
clutch motor(4P)