Sam K Steel II Assembly Instructions

SAM 'K Steel II' Professional American Pool Table
Assembly Instructions
Before beginning assembly, check all accessory bags and confirm all necessary parts
are enclosed. Familiarise your self with the different components and which
fasteners are required for which purposes. Mark out on the floor, where the frame
is to be erected.

1) Assemble Base Frame

Unspin feet a couple of turns to allow a 13mm spanner to fit under the leg to adjust feet
Bolt 2 long sections to legs, do not tighten fully
Bolt 2 cross bearers to long sections, do not tighten fully
Bolt 2 end sections to legs, do not tighten fully
Ensure the threaded holes for the slate support bolts are uppermost on the steel frame
sections.
Tighten all bolts.
Position frame before slates are fitted. Check cueing clearance around the table for final
positioning. It is easier to move before the slates are in place!
2) Fit Aprons - Fit the arched panels between the legs

3) Locate Levellers

Level base frame on feet adjusters (13mm open end spanner on flats of the foot studs).
Fit the 24 nuts onto levelling bolts, into base frame.
Centre levelling bolts are already fitted on cross bearers
Insert the bolts from the underside. When bolt is through the frame and 3mm proud, sit
the platform washers on top.

4) Position Slates

Place slates on top of the platform washers ensuring washers align correctly with the cut-
outs on the tacking strips, (wooden strips on underside of slates), so when tightened they
screw up to the slate.
Insert the pull down bolts through the countersunk holes in the slates and the frame
below.
SAM Leisure Coventry England
Tel +44 (0)24 7646 1234 Fax +44 (0)24 7646 4433
sales@samleisure.co.uk www.samleisure.co.uk