Panasonic KX-TD816 Installation Quick Manual page 4

Display (If disabled): Rejected
The Cell Station (CS) may not be connected or not working. After connecting the CS
or resetting the PBX, wait for at least one minute and try again from the beginning.
(With a PS)
6.
Press the POWER button for a while (about 5 seconds).
7.
Press the FUNCTION button.
8.
Press the FUNCTION button again.
Or Press the UP/DOWN button repeatedly until "PROGRAM" is selected and then press the
SELECT button.
9.
Press the UP/DOWN button repeatedly until the display below is selected.
Display: INITIAL SETTING
10.
Press the SELECT button.
11.
Press the UP/DOWN button repeatedly until the display below is selected.
Display: REGISTRATION
12.
Enter the SELECT button.
13.
Press the UP/DOWN button repeatedly until the desired DECT system number is
selected.
Display example:REGISTRATION
14.
Press the SELECT button.
Display example: ENTER PASSWORD
15.Enter the PS password
Display example: ENTER PASSWORD
16.
Press the AUTO/OK button.
Display: EXECUTING
You will hear a confirmation tone and the display changes as follows.
Display example: DECT-SYS LOCK
17.
Enter the UP/DOWN button to select "DISABLE" or "ENABLE" for the System Lock.
Display example: DECT-SYS LOCK
4
DECT-SYS 1
DECT-SYS 2
=--------
.
=****----
ENABLE
DISABLE