WarmingTends CFB120LP Installation Manual page 26

STEP 4:
Install push
button module into
mounting bracket.
1) Unscrew button cover.
2) Remove plastic nut.
3) Insert washer #1onto
the button stem.
4) Insert push button
stem through mounting
bracket hole.
5) Insert washer #2.
6) Put on plastic nut and
turn until push button
control has been secured
to mounting bracket.
7) Insert AAA battery into
button stem.
8) Screw on button cover.
STEP 5:
Crimp Spark
Igniter wires, then slide
crimped wires on to
connections using needle
nose pliers. Be careful
not to break connectors.
Wires can go in either
connection.
STEP 6:
Test Spark Igniter and Push Button Module WITHOUT gas, making sure spark arcs from electricity to jet.
STEP 7:
Test with gas. Burner should light within 5 seconds or a few clicks.
26
Push Button Ignition
Push Button
Module
Button Stem
Washer #1
Washer #2
Nut
AAA Battery
Button Cover
Spark Igniter Wires
Push Button
Module
Key Valve
Mounting
Bracket
Key Valve
Mounting
Bracket