Advertisement
EXTERNAL CONNECTION
WIRING DIAGRAM
Wiegand Data 0 Out
Wiegand Data 1 Out
Tamper Switch Out(NC)
Tamper Switch Out(COM)
CONTROLLER
Buzzer Control In
LED Control In(Green)
LED Control In(Orange)
Category
Power Supply Unit
Wiegand Connection
LED Control
Buzzer Control
Tamper Control
RS-232 Connection
Green
White
Light yellow
Pink
Yellow
Gray
Connect the DC+12V to the red line.
Connect GND to the black line.
Connect the green line of the product to the Wiegand D0 input port of the controller.
Connect the white line of the product to the Wiegand D1 input port of the controller.
Enables you to turn on or off the LED indicators.
To control green indicator, connect the yellow line to the controller's output (relay). Connect the Gray to
control the orange indicator, connect the white with red stripes to control the red indicator. (see page 12)
Enables you to turn on or off the buzzer.
To control the buzzer, connect the blue line to the controller's output (relay). (see page 12)
Connect the COM port (Pink line) of the product's tamper switch to GND; connect the NC port (Light yellow)
of the tamper switch to the input port of the controller.
Connect to the COM port of the PC. (Connect pin 2 of the DB-9 connector to the purple line; connect the
black of the device (RS-232 GND) to pin 5 of the DB-9 connector)
SSA-R2001V
RS-232(TX)
Purple
Blue
RS-232(GND)
Black
SSA-R2001V
Red
Black
DC +12V
GND
POWER
Cable Wiring
English
PC
English _ 11
Advertisement
