Shure AD1 Manual
  1. Manuals
  2. Brands
  3. Shure Manuals
  4. Transmitter
  5. AD1
  6. Manual

Shure AD1 Manual

Bodypack transmitter
Hide thumbs Also See for AD1:
Table of Contents

Advertisement

Quick Links

See also: Manual
WARNING
•
Battery packs may explode or release toxic materials. Risk of fire or
burns. Do not open, crush, modify, disassemble, heat above 140°F
(60°C), or incinerate.
•
Follow instructions from manufacturer
•
Only use Shure charger to recharge Shure rechargeable batteries
•
WARNING: Danger of explosion if battery incorrectly replaced. Replace
only with same or equivalent type.
•
Never put batteries in mouth. If swallowed, contact your physician or local
poison control center
•
Do not short circuit; may cause burns or catch fire
•
Do not charge or use battery packs other than Shure rechargeable bat-
teries
•
Dispose of battery packs properly. Check with local vendor for proper
disposal of used battery packs.
•
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like
AD1 Axient Digital Bodypack Transmitter
AD series bodypack transmitters deliver impeccable audio quality and RF
performance with wide-tuning, High Density (HD) mode, and encryption. The
transmitter features durable metal construction, AA or SB900A rechargeable
power (with dockable charging), and TA4 or LEMO3 connector options.
Features
Performance
•
20 Hz to 20 kHz range with flat frequency response
•
Automatic input staging optimizes gain setting
•
AES 256-bit encryption-enabled for secure transmission
•
>120 dB dynamic range
•
100 meter (300 feet) line-of-sight operating range
•
Selectable modulation modes optimize performance for spectral efficiency
⁃
Standard – optimal coverage, low latency
⁃
High density – dramatic increase in max system channel count
Included Components
AA alkaline batteries (2)
¼ wave antenna
Threaded TAF4 adapter
Transmitter carrying case
Zipper bag
Belt clip

Optional Accessories

©2016 Shure Incorporated
WARNING: Danger of explosion if incorrect battery replaced. Operate only
with AA batteries.
Note: Use only with the included power supply or a Shure-approved equiva-
lent.
Please follow your regional recycling scheme for batteries, packaging, and
electronic waste.
WARNING: This product contains a chemical known to the State of California
to cause cancer and birth defects or other reproductive harm.
低功率電波輻射性電機管理辦法
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得
擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現
象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依
電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科
學及醫療用電波輻射性電機設備之干擾。
•
•
•
Design
•
•
•
•
•
Power
•
•
•
80B8201
Varies by Region
WA340
WA610
26A13
44A12547
Built-in tone generator and RF markers to facilitate walk-testing
Switchable Power Levels = 2/10/35 mW (region dependent)
Frequency Diversity selection using two bodypacks
TA4 or LEMO3 audio connector option
Backlit LCD with easy to navigate menu and controls
Rugged metal construction
Flexible ¼ wave antenna
Menu and power lockout
Over 8 hours continuous use with 2 x AA alkaline batteries
Shure SB900A lithium-ion rechargeable battery provides extended battery
life, precision metering, and zero memory effect
External charging contacts for docked charging
AD1
AD1 Bodypack Transmitter
1/12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AD1 and is the answer not in the manual?

Questions and answers

Related Manuals for Shure AD1

Summary of Contents for Shure AD1

  • Page 1: Optional Accessories

    WARNING: Danger of explosion if incorrect battery replaced. Operate only burns. Do not open, crush, modify, disassemble, heat above 140°F with AA batteries. (60°C), or incinerate. Note: Use only with the included power supply or a Shure-approved equiva- • Follow instructions from manufacturer lent.

  • Page 2: Updating Firmware

    Use to navigate through parameter menus and to change settings. ⑤ Battery Compartment Requires two AA batteries or Shure SB900A rechargeable battery. ⑥ AA Battery Adapter Use to secure AA batteries. Remove when using a Shure SB900A battery. ⑦ SMA Connector Connection point for RF antenna. ⑧ Power Switch Powers the unit on or off.

  • Page 3: Locking The Controls

    AD1 Bodypack Transmitter Shure Incorporated Acts as a 'back' button to return to previous menus or parameters exit exit enter without confirming a value change enter Enters menu screens and confirms parameter changes Use to scroll through menu screens and to change parameter ∨∧...

  • Page 4: Shure Sb900A Rechargeable Battery

    AA Batteries: Place batteries (note polarity markings) and AA Adaptor as shown and close the door • Shure SB900A Battery: Place battery as shown (note polarity markings). Remove the AA adapter and set it aside. Close the door to secure the battery. Note: If using AA batteries, set the battery type using the transmitter menu.

  • Page 5: Aa Batteries And Transmitter Runtime

    Remaining (hours:minutes) • During storage, check batteries every 6 months and recharge to 40% of capacity as needed 11:00 - 8:00 For additional rechargeable battery information, visit www.shure.com. > 5:00 > 2:00 AA Batteries and Transmitter Runtime ≦ 2:00 Transmitters are compatible with the following AA battery types: ≦...
  • Page 6 When enabled, press the enter button to drop a marker in Wireless Work- bench. Battery Displays battery information: • Battery: The chemistry type of for the installed battery (Shure Radio Menu Rechargeable, Alkaline, Lithium, NiMH) • Bars: Indicates the number of bars displayed G: and C: Group and Channel Press the enter button to enable editing of a group (G:) or channel (C:).

  • Page 7: Setting The Frequency Manually

    AD1 Bodypack Transmitter Shure Incorporated 2. Tune the channel to an available frequency using group scan or manually turn to an open frequency. 3. Power on the transmitter. 4. Press the SYNC button on the receiver. 5. Align the IR windows between the transmitter and the receiver so that the IR LED illuminates red. When complete, Sync Success! appears. The transmitter and receiver are now tuned to the same frequency.

  • Page 8: Input Overload

    AD1 Bodypack Transmitter Shure Incorporated 1. From the Radio menu, navigate to RF Output. 2. Choose one of the following options: RADIO RF Output: Mute ⁃ On: RF signal is active ⁃ Mute: RF signal is disabled 3. Press enter to save.
  • Page 9 AD1 Bodypack Transmitter Shure Incorporated Battery Type Shure SB900A Rechargeable Li-Ion or LR6 AA batteries 1.5 V Battery Runtime @ 10 mW Shure SB900A up to 9 hours alkaline up to 8 hours Dimensions 86 mm x 66 mm x 23 mm (3.4 in. x 2.6 in. x 0.9 in.) H x W x D Weight 155 g (5.0 oz.), without batteries...

  • Page 10: Frequency Bands And Transmitter Rf Power

    AD1 Bodypack Transmitter Shure Incorporated Power 2 mW, 10 mW, 35 mW Frequency Bands and Transmitter RF Power Band Frequency Range (MHz) RF Power (mW)*** 470 to 510 2/10/35 479 to 565 2/10/20 470 to 636* 2/10/35 470 to 636...
  • Page 11 AD1 Bodypack Transmitter Shure Incorporated Country Code Frequency Range Code de Pays Gamme de frequences Codice di paese Gamme di frequenza Código de país Gama de frequencias Länder-Kürzel Frequenzbereich A, B, BG, CH, CY, CZ, D, DK, EST, F FIN, GB, GR, H, HR, I, IRL, IS, L, LT...
  • Page 12 : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: info@shure.com 12/12...

Table of Contents