Page 1
Wing Span:64in/1625mm; Flying Weight:2700g; Wing Area:50.1sq.dm; Radio:4Channel 6Servos; Length:59 in/1500mm; Engine:20CC Gas CAUTION CAUTION CAUTION : : : : this this this plane plane plane is is is is not not a a a a toy should should kept kept away away CAUTION...
Page 2
MAIN MAIN WING WING MAIN MAIN WING WING Apply epoxy into hinge hole of the wing Connect the aileron and the main wing by hinges. Be sure to apply instant type glue to both sides of each hinges. Cut the servo holes on the bottom of the main wings...
Page 3
Use glue to fix up the horns Install push-rod,used ruler to measure the length Put the servo into the hole and fix it with screws.
Page 4
Link the servo arms and tri-horns with pushrod Drill the holes on the wing tips Be assured that the screw is fixed up INSTALL WINGTIP WINGLET...
Page 5
You can also install wingtip winglet,as shown. STABILIZER STABILIZER ELEVATOR ELEVATOR STABILIZER STABILIZER AND AND ELEVATOR ELEVATOR Cut the servo holes on the profile of the fuselage Fix up the stabilizer of the fuselage...
Page 6
Apply epoxy into hinge hole of the elevator Fix up the stabilizer and elevator with hinges and AB glue. Use glue to fix up elevator horns Install the servo in the hole as shown Be assured that the screw is fixed up...
Page 7
Link the servo to the elevator with pushrod. RUDDER RUDDER RUDDER RUDDER Apply epoxy into hinge hole of the rudder Use glue to fix up rudder horns...
Page 8
Install the rudder servo Be assured that the screw is fixed up attach the servo arm to the ruddert servo as shown As shown in picture, This is finished for the rudder servo...
Page 9
MAIN MAIN LANDING LANDING GEAR GEAR MAIN MAIN LANDING LANDING GEAR GEAR Fix up the landing gear on the fuselage bottom with screws. ● Bottom View Put the cover board in the right position,then fix up it. Install the wheel as shown. Install the wheel cover, and fix it up to landing gear with screw.
Page 10
Install the tail landing gear use screws to fix up the fuselage bottom. ENGINE ENGINE ENGINE ENGINE Drill the engine mounting holes as the board provided Use the ruler to measure the length from firewall to airscrew P.10...
Page 11
Put the cover board in the hole,then fix up it. Install the propeller and spinner as shown FUEL TANK FUEL TANK FUEL FUEL TANK TANK Install the fuel tank into the fuselage, and fix up it with belt. P.11...
Page 12
Install the fuel tank mounting ties under the fuel tank floor. Install the battery,receiver and switch in place as shown. CANOPY COWL CANOPY COWL CANOPY CANOPY AND AND COWL COWL Install the canopy into the fuselage as shown P.12...
Page 13
Mount the cowl using the cowl mounting screws. POSITION POSITION POSITION & & & & CONTROL CONTROL CONTROL THROWS THROWS CG POSITION CONTROL THROWS THROWS P.13...
Need help?
Do you have a question about the MXS-R 64 and is the answer not in the manual?
Questions and answers