AEG L 61271 BI User Manual page 31

2
1
A
B
C
E
Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth12.5-14 mm
depending on the depth of door furniture) on
the inner side of the door.
The distance between the hole fixing centres
must be 416 mm. The distance from upper
edge of the door to the centre of the hole
depends on the adjacent furniture's
dimensions.
The hinges will be fixed to the door by means
of screws for wood 1 and 2 supplied with the
appliance.
Mounting the door
Fix the hinges to the appliance by means of
the M5x15 screws.
The hinges can be adjusted to compensate
for possible uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tighten
the screw A again.
Counter-magnet
A
B
The appliance is pre set for a magnetic door
closure. To position the closure correctly, it is
necessary to screw the counter-magnet A
(steel disk + rubber ring) into the inner side of
C
the door.
Its position must correspond to the magnet B
on the appliance.
D
If the door has to be opened from left to
right, invert the position of the plates E, the
A
magnet D and the plate C. Mount the
counter-magnet D and the hinges A as
previously described.
B
WARNING!
Do not remove the screw B.
WARNING!
Do not remove the screw B.
WARNING!
Do not remove the screw B.
ENGLISH 31