Terminate An Active Conference; Viewing The End Of Conference Summary Report - NEC Univerge SV8100 User Manual

SV8100
___________________________________________________________________________________
2.29
2.30
___________________________________________________________________________________
SV8100 RGA Application Gateway Conference User Guide
3. Enter up to eight vote digits.
4. Press #.
5. To end the round of voting, press 56#.

Terminate an Active Conference

This control allows you to terminate an active conference.
1. Press *0# to disconnect all participants and the moderator from the
conference call.
 Only the conference Moderator has the privilege to enable this
feature.

Viewing the End of Conference Summary Report

If the System Administrator has enabled the feature, and you have selected
the option Send email summary reports under Email Settings in your Account
Profile, you will receive an email with an end of conference summary report
when your conference is over, as shown below.
Figure 1-23 The End of Conference Summary Report
Revision 1.0
1 - 31