Related Manuals for TECHCON SYSTEMS TS250
Summary of Contents for TECHCON SYSTEMS TS250
- Page 1 Techcon Systems TS250 Precision Dispensers User Guide English version Copyright © OK International & Bergdahl Associates, Inc.
-
Page 2: Table Of Contents
CONTENTS Page Number Safety ……………………………………………………………2 Symbol Definitions …………………………………………………3 Specifications ……………………………………………….…………...3 Features ……………………………………………………………4 Connecting the Unit ……………………….…….………..…………5 Setup Instructions …………………………………………………5 Troubleshooting …………………………………………………6 Maintenance ……………………………………………………………7 Spare Parts and Accessories ………………………………………7 10. Warranty ……………………………………………………………7 11. I/O Configuration and End of Cycle Switch ……………………….…...8 SAFETY 1.1 Intended Use: WARNING: Use of this equipment in ways other than those described in this User... -
Page 3: Symbol Definitions
-10 C to 60 C (14 F to 140 F) 80% for temperature up to 31 C (87.8 F) Decreasing Max. Relative Humidity linearly to 50% relative humility at 40 C (104 F) TS250 = 0-100 psi (0- 6.9 bar) Air Output TS255 = 0-15 psi (0-1 bar) Vacuum 406mm (16”) of Hg... -
Page 4: Features
FEATURES Figure 1.0 Items Description Power Button Mode Button Counter Reset Button Display Air Pressure Gauge Air Pressure Regulator Pulsed Air Outlet Vacuum Control Time Control Knob Receiver head air hose holder Foot Switch Receptacle Power Receptacle I/O Connection Exhaust Port Air Inlet Cord Lock... -
Page 5: Connecting The Unit
CONNECTING THE UNIT CAUTION: A 5-micron filter (TSD800-6), not included, must be installed with the unit to ensure proper air filtration. Figure 2.0 Items Description To Air Source Air Filter (Not included) Power Adapter Foot Switch SETUP INSTRUCTIONS Refer to Figure 1.0 6.1 Manual Dispense Cycle Setting: 1. -
Page 6: Troubleshooting
6.3 Cycle Counter The cycle counter records the numbers of dispense cycle being activated. Up to 65,535 cycles can be recorded. This number is shown at the lower right hand corner of the LCD. Press the Counter Reset button (3) to clear the counter. -
Page 7: Maintenance
Avoid connecting the unit to excessive moisture or solvent saturation. Avoid connecting air supply exceeding 100 psi (6.9 bar) for the TS250 and 15 psi (1.03 bar) for the TS255. Use only Amyl Alcohol to clean outside surface of the main housing. -
Page 8: 11. I/O Configuration And End Of Cycle Switch
Note: During the dispense cycle, pin 3 will be grounded. Please make sure the external device (your machine that controls the dispenser/controller) has the same ground as the TS250/255 controller. Pin 1 (+) To initiate a dispense cycle with voltage...
Need help?
Do you have a question about the TS250 and is the answer not in the manual?
Questions and answers