Configuring Routing Between A Pe And A Ce - HP FlexNetwork 10500 Series Configuration Manual

Step
4. Set the maximum
number of active routes.
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to
the VPN instance.

Configuring routing between a PE and a CE

You can configure static routing, RIP, OSPF, IS-IS, EBGP, or IBGP between a PE and a CE.
Configuring static routing between a PE and a CE
Step
1. Enter system view.
2. Configure a static
route for a VPN
instance.
Command
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
Command
system-view
ip route-static vpn-instance
s-vpn-instance-name dest-address
{ mask-length | mask } { interface-type
interface-number [ next-hop-address ]
|next-hop-address [ public ] [ track
track-entry-number ] | vpn-instance
d-vpn-instance-name next-hop-address
[ track track-entry-number ] } [ permanent ]
[ preference preference ] [ tag tag-value ]
[ description text ]
204
Remarks
By default, the number of active
routes is not limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from learning
too many routes.
By default, all routes matching the
import target attribute are
accepted.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing). The
LSP tunnel takes precedence
over the CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."
Remarks
N/A
By default, no static route is
configured for a VPN
instance.
Perform this configuration on
the PE. On the CE, configure
a common static route.
For more information about
static routing, see Layer
3—IP Routing Configuration
Guide.