Transferring Data - Docomo AQUOS PHONE SH-10D Instruction Manual

1
Connect the handset to a PC via
Micro USB Cable 01
: The USB mass storage screen appears. If
the screen does not appear, drag the status
bar down and select [USB connected].
2
[Turn on USB storage]
: When the confirmation screen is displayed,
check the content and select [OK].
3
Use as a microSD reader/writer
4
Perform secure hardware removal
on the PC after use
5
[Turn off USB storage]
6
Disconnect Micro USB Cable 01
from the handset
While using as a microSD reader/writer,
microSD Card cannot be used by other
applications. In addition, microSD Card may not
be used as a microSD reader/writer while it is
used by other applications.

Transferring data

Transfer data from a PC to the handset memory
or a microSD Card.
Set the mode of USB connection (nP. 100) to
[MTP mode] in advance. When using a PC not
compatible with MTP, set the mode to [PTP
mode].
1
Connect the handset to a PC via
Micro USB Cable 01
: When the MediaJet installation screen is
displayed, select [Skip].
2
Transfer data
3
Remove Micro USB Cable 01 from
the handset after use
Using MediaJet
Install MediaJet on a PC to transfer music data/
videos/still pictures on the handset and the PC.
Installing MediaJet
Set the mode of USB connection to [MTP mode]
and enable MediaJet install in advance
(nP. 100). Also, connect a PC to the Internet in
advance.
1
Connect the handset to a PC via
Micro USB Cable 01
2
[Install]
: The installation will start on the PC. Follow
the instructions on the screen and operate
after this step.
To install MediaJet from a PC, refer to the
following site.
( h ttp://mediaJet.nero.com)
Transferring data by USB connection
Set the mode of USB connection (nP. 100) to
[MTP mode] in advance. When using a PC not
compatible with MTP, set the mode to [PTP
mode].
1
Activate MediaJet on a PC
2
Connect the handset to the PC via
Micro USB Cable 01
: When the MediaJet installation screen is
displayed, select [Skip].
3
Use MediaJet
ance
113
File Management