Remote Control Programming - Craftmatic L-132 Owner's Manual

remote controL Programming (1 remote control - 1 base)
Program One Remote to Operate One Base - Bases are
factory programmed to operate as one remote control
to one base. If reprogramming is required, perform the
following numbered procedure. If programming fails,
initiate the programming procedure a second time.
steP 1
Plug the base into the electrical power source.
steP 2
Locate the control box (attached to the underside of
the base) (FIGURE 8).
steP 3
Simultaneously press and hold the learn button
on the control box (FIGURE 8) and the head up
button on the remote control (FIGURE 9). Hold
both buttons until the base begins to move or the
massage motors start. Release both buttons.
One remote control is now programmed to operate
one base.
FIGURE 8
CONTROL
BOx
LEARN
BUTTON
HEAD UP
BUTTON
FIGURE 9
Craftmatic
15
L-132 290-0001-b
®