Table of Contents
Advertisement
Quick Links
Charter Spectrum Remote Control User Guide
URC1160
Image of remote line art
Getting Started: Install Batteries
1. Apply pressure with your thumb and slide the battery door for removal
Show image of bottom of remote, indicating pressure point and slide direction
2. Insert 2 AA batteries. Match the + and – marks.
Show illustration of batteries in place
3. Slide the battery door back into place.
Show bottom of remote with battery door in place, include arrow for slide direction.
Setup Your Remote for a Charter WorldBox
If you have a Charter WorldBox, the remote must be paired with the box. If you do NOT have a
WorldBox, proceed to PROGRAMMING YOUR REMOTE FOR ANY OTHER CABLE BOX.
To Pair the Remote to the WorldBox
1. Ensure that your TV and WorldBox are both powered-on and that you can view the video feed
from the WorldBox on your TV.
Show image of STB and TV connected and on
2. To pair the remote, simply point the remote at the WorldBox and press the OK key. The Input
key will begin blinking repeatedly.
Show image of remote pointed at the TV, transmitting data
3. A confirmation message should appear on the TV screen. Follow the on-screen instructions to
program the remote control for your TV and/or audio equipment as needed.
To Un-Pair the Remote to the WorldBox
If you wish to use the remote with a different cable box, follow these steps to un-pair it with your
WorldBox.
1. Press and hold MENU and Nav Down keys simultaneously until the INPUT key blinks twice.
Show remote with MENU and Nav Down keys highlighted
2. Press 9-8-7 digit keys. The INPUT key will blink four times to confirm pairing has been disabled.
Show remote digits with 9-8-7 highlighted in order.
MUG1160S-A1
Page 1
Advertisement
Table of Contents
Related Manuals for Spectrum URC1160
Summary of Contents for Spectrum URC1160
- Page 1 Charter Spectrum Remote Control User Guide URC1160 Image of remote line art Getting Started: Install Batteries 1. Apply pressure with your thumb and slide the battery door for removal Show image of bottom of remote, indicating pressure point and slide direction 2.
- Page 2 Programming Your Remote for Any Other Cable Box This section is for any cable box that is NOT a Charter WorldBox. If you have a WorldBox, refer to the section above for remote pairing, following the on-screen instructions for any other remote programming.
- Page 3 NOTES: While holding the digit key, the remote will test for the working IR code, causing the INPUT key to flash each time it tests a new code. Setup Using Direct Code Entry This step covers setup for all TV and Audio brands. For faster setup, be sure to locate your device brand in the code list before beginning setup.
-
Page 4: Declaration Of Conformity
Problem: My remote won’t pair with my Cable Box Solution: Ensure that you have a Charter WorldBox Ensure that the remote has a clear line of sight to the Cable Box when pairing Be sure to follow the on-screen instructions that appear when pairing Remote Key Chart Show image of the whole remote control with lines pointing to each key or key group for the description below.
Need help?
Do you have a question about the URC1160 and is the answer not in the manual?
Questions and answers
remote does not fast forward
The Spectrum URC1160 remote may not fast forward because of a problem with the cable box, not the remote itself. A possible fix is to perform a cold reboot by turning off and unplugging the cable box and TV for five minutes. After plugging them back in and letting the box fully reboot, test the fast forward function on a fully recorded show. If the issue continues, a technician may need to check the signal and perform a drop line test.
This answer is automatically generated