Power Fault Leds - HP APOLLO 2000 User Manual

Item Description
1 Power button/LED
2 UID button/LED
3 Health LED
4 Do not remove LED
5 iLO activity LED
6 iLO link LED
7 NIC link LED
8 NIC activity LED
1
When the LEDs described in this table flash simultaneously, a power fault has occurred. For more
information, see "Power Fault LEDs."
2
Facility power is not present, power cord is not attached, no power supplies are installed, power supply
failure has occurred, or the front I/O cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the
system health status.

Power fault LEDs

The following table provides a list of power fault LEDs, and the subsystems that are affected. Not all power
faults are used by all servers.
1
1
1
1
1
Status
Solid green = System on
Flashing green = Performing power on
sequence
Solid amber = System in standby
2
Off = No power present
Solid blue = Activated
◦ 1 flash per second = Remote management
or firmware upgrade in progress
◦ 4 flashes per second = iLO manual soft
reboot sequence initiated
◦ 8 flashes per second = iLO manual hard
reboot sequence in progress
Off = Deactivated
Solid green = Normal
Flashing amber = System degraded
Flashing red = System critical
Flashing white = Do not remove the node.
Removing the node may terminate the current
operation and cause data loss.
Off = The node can be removed.
Green or flashing green = Network activity
Off = No network activity
Green = Linked to network
Off = No network connection
Green = Linked to network
Off = No network connection
Green or flashing green = Network activity
Off = No network activity
3
Power fault LEDs 21