Bluetooth; Removing The Bluetooth - Toshiba QOSMIO E10 Maintenance Manual

4.5 Keyboard/Bluetooth

4.5.2 Bluetooth

Removing the Bluetooth

The following describes the procedure for removing the bluetooth (See Figure 4-10).
1. Disconnect the bluetooth flat cable from the connector PJ4400 on the system board.
2. Pull out the bluetooth module from the guide of the display assembly.
3. Disconnect the bluetooth antenna cable (brown cable) from the bluetooth module.
4. Disconnect the bluetooth flat cable from the connector on the bluetooth module.
bluetooth antenna cable
bluetooth module
Installing the Bluetooth
The following describes the procedure for installing the bluetooth (See Figure 4-10).
1. Connect the bluetooth flat cable to the connector on the bluetooth module.
2. Connect the bluetooth flat cable to the connector PJ4400 on the system board.
3. Fit the bluetooth module to the guide of the display assembly.
4. Connect the bluetooth antenna cable (brown cable) to the bluetooth module.
QOSMIO E10 Maintenance Manual (960-492)
bluetooth flat cable
Guide
Figure 4-10 Removing the bluetooth module
4 Replacement Procedures
PJ4400
4-21