PrecisionTemp RV-550 Installation, Operation And Maintenance Manual

PrecisionTemp RV-550 Installation, Operation And Maintenance Manual

Lpg gas on demand water heater

Advertisement

11 Sunnybrook Drive
Cincinnati, OH. 45237
Phone: 513-641-4446 * 800-934-9690
Fax:
513-641-0733
www.precisiontemp.com
This water heater design has been certified by the Canadian
Standards Association for installation in recreation vehicles. This
water heater is not for use in space heating applications.
SERVICE CALLS & QUESTIONS
Locations and phone numbers of qualified Service Centers can
be found at our website www.precisiontemp.com or
800-934-9690 Ext. 109 to obtain service information.
call
WARNING: If the information in these
instructions is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
—Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Evacuate all persons from the
vehicle.
• Shut off the gas supply at the
gas container or source.
• Do not touch any electrical
switch, or use any phone or radio
in the vehicle.
• Do not start the vehicle's engine
or electric generator.
• Contact the nearest gas supplier
or qualified service technician for
repairs.
• If you cannot reach a gas
supplier or qualified service
technician, contact the nearest fire
department
• Do not turn on the gas supply
until the gas leak(s) has been
repaired.
Installation and service must be
performed by a qualified installer,
service agency, OEM or the gas supplier.
Installation, Operation and Maintenance
Effective 1/13
CRITICAL INSTALLATION WARNINGS
• Install in recreation vehicles only. RV's are recreation
vehicles designed as temporary living quarters for
recreation, camping, or travel use having their own power or
towed by another vehicle.
• All combustion air must be supplied from outside the RV,
and all products of combustion must be vented to outside
the RV.
• DO NOT vent water heater with venting system serving
another appliance.
• DO NOT vent water heater to an outside enclosed porch
area.
• Protect building materials from flue gas exhaust.
• Install water heater on an exterior wall, with access door
opening to outdoors.
• DO NOT modify water heater in any way.
• DO NOT alter water heater for a positive grounding
system.
• DO NOT HI-POT water heater unless electronic ignition
system (circuit board) has been disconnected.
• DO NOT use battery charger to supply power to water
heater even when testing.
Do not install close to opening door or under room slide-out
where the vent or inlet louvers can be obstructed.
USA and Canada – Follow all applicable state
and local codes. In the absence of local codes or
regulations, refer to the current standards of:
Local codes or, in the absence of local
codes, the National Fuel Gas Code, ANSI
Z223.1/NFPA 54 and/or CSA B149.1,
Natural Gas and Propane Installation
Code.
Local codes or, in the absence of local
codes, the Standard on Recreational
Vehicles, NFPA1192 and/or CAN/CSA-
Z240 RV.
CUTOUT Requirements
OEM and Aftermarket – Unit can be installed in
PrecisionTemp, Suburban and Girard openings. Unit can also
be installed through the wall from exterior, or prior to erecting
wall into place at OEM manufacturing facility.
Rough opening:
1
LPG GAS ON DEMAND
WATER HEATER
Model
RV-550
14.25" min. - 16.5" max High
13.5" min - 17.25" max Wide
17" min Deep

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RV-550 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PrecisionTemp RV-550

  • Page 1 CUTOUT Requirements repaired. OEM and Aftermarket – Unit can be installed in PrecisionTemp, Suburban and Girard openings. Unit can also Installation and service must be be installed through the wall from exterior, or prior to erecting wall into place at OEM manufacturing facility.
  • Page 2: General Installation

    Consult your Field Auditor, Account Manager, or Erect the side walls and cut the opening or the PrecisionTemp Service Department if you have additional orient the pre-fabricated opening. Frame with questions.
  • Page 3: Pressure Relief Valve

    PRESSURE RELIEF VALVE WIRING INSTRUCTIONS The appliance, when installed, must be electrically grounded in accordance with local PRESSURE RELIEF VALVE codes or, in the absence of local codes, with the WIRING INSTRUCTIONS National Electrical Code, ANSI/NFPA 70 and/or The appliance, when installed, must be the CSA C22.1, Canadian Electrical Code.
  • Page 4 Pressurize the water system by turning on pump or city water pressure. Purge all air from the system by turning on the faucets until a steady stream of water flows. Turn on the 12V DC power supply. Turn on the LP supply at the tank and the manual gas valve (if installed).The water heater will remain dormant until a water tap is opened and the heater senses water flow of at least 0.5 GPM.
  • Page 5 1315 2454 1411 1375 1385 1073 3366! 2028 3477 3476 3369 3503 3521 3438 3333 3527 3390 3329 3388 2086 3442...
  • Page 6: Troubleshooting

    If problems still persist, air. contact PrecisionTemp or an authorized service 2. Be sure that water flow is at least 0.5 gallon/ center. Only a qualified technician should do any minute.
  • Page 7: Limited Warranty

    (under 3/8 inch outside diameter). The 1. For a period of two years from the date of purchase, PrecisionTemp gas line may be excessively long (over 20-30 feet) or will replace the complete water heater if the heat exchanger leaks due to corrosion.

Table of Contents