Do you have a question about the GoFish Cam and is the answer not in the manual?
Questions and answers
GEORGE MILLER
February 21, 2025
bought gofish camera years ago nev er used it tried it for first time it will not hold its power therefor only connects while on mains charging power supply
1 comments:
Mr. Anderson
February 21, 2025
The GoFish Cam may not hold its power and only work while plugged in due to a worn-out battery. If the operating time is very short even after being fully charged, the battery may have degraded. Additionally, battery performance can decrease in cold environments. If the device is still within one year of purchase, contacting GoFish Cam for warranty support is recommended.
This answer is automatically generated
Summary of Contents for GoFish GoFish Cam
Page 1
GoFish Cam Underwater Fishing Camera Basic Owner’s Manual August 10, 2017 Version: 0.012...
Thank you for purchasing the GoFish Cam – the underwater, inline fishing Camera. Please review these instructions carefully before using the product and save this manual for future use. You will need to download the iOS application or Android application in order to register your GoFish Cam. Please register your camera before using it.
You will need to download the iOS application or Android application in order to register your GoFish Cam. Please register your camera before using it. Please see the app description pages on the iOS App Store or Google Play store for minimum system requirements for your device.
Page 4
Using this unit for trolling Using this unit for bottom fishing Using this unit for float fishing - with the GoFish Cam live-stream float accessory Do not open the unit when the accessory is attached. Remove accessory, dry the surface of the unit, before opening either end of the unit.
Page 5
Caution About this unit About personal information Disclaimer About the microSD card About firmware updates Manually resetting the unit About the battery Disposal of the product at end of life About Copyright...
5 sets of devices, and passing the 26 orientation drops within 5 devices. (If failure occurs during the test, a new set is used to pass the drop orientation test within a total of 5 devices.) GoFish Cam’s test method is based on the above “MIL-STD 810G Method 516.5-Shock”.
Handling of this unit ● The waterproof performance may be degraded due to the strong water pressure when this unit is used deeper than 150m (492 Feet) underwater. GoFish Cam does not recommend using this unit deeper than 150m. ●...
Cap or Lens Cap near open water, underwater, with wet hands, or when the unit is wet. Doing so may cause water to leak in. If you attach/remove the Rear Cap or Lens Cap in a sandy or dusty place, sand or other foreign objects may adhere to the internal components, threaded portions (portions of this unit, Rear Cap and Lens Cap with helical threads), rubber seals or other parts of this unit.
Check before using underwater Do not attach/remove the Rear Cap or lens cap in sandy or dusty locations, near water, or with wet hands. If sand or dust adheres to this unit, water may leak in. Step 1: Rotate the Rear Cap and lens cap in the directions of the arrows to remove them.
To prevent water from seeping into the unit, be careful not to trap foreign objects like sand, hair, or dust between the rear cap / lens cap and the main unit. Using this unit underwater ● Use this unit underwater at a depth of down to 150M (492 feet) with the water °...
C / 32F, such as ice fishing, northern waters, deep waters, winter climates, or places at high altitude) for a long period of time. GoFish Cam will not be held liable for any such injuries. ● The performance of the battery (recording time / operating time) may decrease °...
Page 12
● If the unit is consistently used in cold places such as ice fishing, northern waters, deep waters, winter climates, or places at high altitude, overall productivity of battery life of unit may decrease over time...
1) Rotate and remove the rear cap to remove it, see page 8 for removal instructions. 2) Connect the USB cable (provided) to the GoFish Cam and connect the other end to a Wall Outlet or a PC. The left indicator light on the back of the unit will turn red to indicate that it is charging.
Charging Warnings ● Do not use any other USB cables except the supplied one. (Operation is not guaranteed with any other USB cables.) ● Do not heat or expose to flame. ● Do not leave the unit (including built-in battery) in a car exposed to direct sunlight for a long period of time with doors and windows closed.
With Lights Note: Battery Life with WiFi on will be diminished. Maximum time with WiFi is 1.5 Hours. We recommend charging this unit while using WiFi to review and edit footage with the "GoFish Cam App"GoFish Cam App“GoFish Cam App”...
Recording to a card Your GoFish Cam can record video to a microSD card allowing you to review the footage at a later time. In order to record video, you will need to use a microSD card with an SD Speed Class Rating of Class 4 or higher. If you use an SD Speed Class Rating with a lower speed rating the recording may stop suddenly or other unexplained behavior may occur.
Inserting/Removing a microSD Card When using a microSD card not supplied from GoFish Cam, or one previously used on other equipment, for the first time on this unit, format the microSD card. Note: When a microSD card is formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be restored.
You will need to download the iOS application or Android application in order to register your GoFish cam. Please see the app description pages on App Store or Google Play store for minimum system requirements for your device. For Android Apps...
Page 21
The Wi-Fi indicator light will turn off ■ ❏ Change the default SSID and Password using the "GoFish Cam App" after entering them for the first time. Visit the settings icon when in live stream view in camera mode. ❏...
Your unit will automatically set the date and time of your videos when you sync with your smartphone. You do not need to do anything, once connected to the "GoFish Cam App" the unit time will be set to the correct time zone you are in.
GoFish Cam or interfering with other fisherman nearby who are also using a GoFish Cam. Format Camera If you are using a new microSD card in your GoFish Cam or if the card was previously used in another electronic device, you should format the card in your GoFish Cam for proper operation.
Formatting a microSD card will erase ALL the data stored on the card, so make sure you have copies of any data that is on the card before performing a formatting operation. Once you format a card, you will not be able to easily recover lost information.
You Attach the GoFish Cam Live-Stream Float Accessory to the camera by sliding the camera into the accessory. Make sure that the GoFish Cam Logo on the accessory is facing the rear cap of the camera. Make sure you slide the accessory onto the camera from the lens side as seen in Figure FF. Make sure the unit is attached to your fishing line before attempting to use the float Do not open the unit when the accessory is attached.
Page 26
Figure AA Figure BB Figure CC Figure DD...
Check before recording When you connect this unit and a smartphone and start up the "GoFish Cam App", you can check the video from this unit on the live view screen. We recommend that you make a test recording to check the angle of view mode, White Balance setting and other settings before recording...
Figure 7 Depending on your OS or the version of the smartphone application "GoFish Cam App", the screen may differ from the one above. ● The live view screen will disappear when the unit disconnects from the WiFi connection. This will happen anytime the unit is in the water.
❏ You can also perform recording on the "GoFish Cam App". Refer to Tutorial in the "GoFish Cam App" profile menu settings for information on how to perform the operation. ❏ When you are recording with the "GoFish Cam App", the recording will continue even if this unit is disconnected from the smartphone. To stop the recording, operate this unit or reconnect to the smartphone.
Note: you can rotate the smartphone to a horizontal orientation to expand video size To save video to your smartphone tap the save icon. To save video to your personal library on the "GoFish Cam App" tap on “Share” and follow those steps. See Share section for more help.
EDITING Editing using a smartphone Videos stored on the MicroSd card in this unit are edited with the smartphone using the "GoFish Cam App". For more information, refer to the Tutorial section in the Personal Library Tab under settings. Figure 9 Connect this unit with the "GoFish Cam App"...
Tutorial section in the Personal Library Tab under settings. Click on the Share button from the edit screen of the GoFish Cam App. From there you can add hashtags, a description of your video, or log specific data about your clip. Then you can post the video to social media sites for...
Using a PC You can use the following functions by connecting this unit to a PC: ● Charging the battery ○ When you connect this unit to a PC, the PC starts charging the battery ● Card Reader Function (Mass Storage) ○...
Page 35
PLAYBACK Problem Check Points When reviewing footage, my videos keep This is not an error. The GoFish Cam is cutting themselves at 1 minute lengths programmed to record in 1 minute clips to easily manage the experience through the...
Page 36
“No Internet Connection” the mobile app, but it is not a WiFi to access the internet. Even with this error message you can still get full use of the "GoFish Cam App" The Wi-Fi connection is not possible between ●...
different device. Caution About this unit This unit and the microSD card become warm during use. This is not a malfunction. ● Keep this unit as far away as possible from electromagnetic equipment (such as microwave ovens, TVs, video games etc.). ○...
Information including personal information may be altered or vanish due to erroneous operation, effect of static electricity, accident, malfunction, repair, or other handlings. Please note in advance that GoFish Cam is not liable in any way for any direct or indirect damage from the alteration or vanishing of information or personal information.
When the microSD card is being accessed (when the unit is recording or WiFi is on and “GoFish Cam App” is being used to control the unit), do not perform the following: ●...
5. Turn on the GoFish Cam unit. The red light will flash indicating update in process. 6. Do not do anything with the GoFish Cam unit until the light is solid indicating it it done with the update 7. Turn the GoFish Cam unit off, remove the microSD and delete the update file.
Under copyright laws, other materials cannot be used without obtaining permission from the holders of the copyrights. Please read the terms and conditions when using the "GoFish Cam App" before use with this unit and the videos recorded with it. Licenses ●...
Need help?
Do you have a question about the GoFish Cam and is the answer not in the manual?
Questions and answers
bought gofish camera years ago nev er used it tried it for first time it will not hold its power therefor only connects while on mains charging power supply
The GoFish Cam may not hold its power and only work while plugged in due to a worn-out battery. If the operating time is very short even after being fully charged, the battery may have degraded. Additionally, battery performance can decrease in cold environments. If the device is still within one year of purchase, contacting GoFish Cam for warranty support is recommended.
This answer is automatically generated