Related Manuals for EVBox BusinessLine series
Summary of Contents for EVBox BusinessLine series
-
Page 1: Installation Manual
Installation Manual EV-Box Charging Station BusinessLine Model Ver. 4 rev. 3 25-05-2016... -
Page 2: Table Of Contents
Table of contents 1. Safety regulations ....................... 3 Transport and storage ..........................3 2. Product description ......................4 General ..............................4 Online – Model with modem ......................... 4 Safety ................................. 4 Mode 3 Controller ........................... 4 Operation ..............................4 Warranty ..............................4 3. -
Page 3: Safety Regulations
1. Safety regulations WARNING: RISK OF ELECTRIC SHOCK. • Please read the documentation provided with the charging station to acquaint yourself with the safety instructions and directions before installing or using the charging station. • The charging station is designed and tested in accordance with international standards. •... -
Page 4: Product Description
2. Product description General The EV-Box charging station (Figure 1) is compatible with all mode 3 electric vehicles. The charging station is meant for both indoor and outdoor use. Usage of the charging station is allowed in an ambient temperature between -25°C and +60°C. The charging station is connected to a central system for registration of the kWh charged. -
Page 5: Control
3. Control Charging stations with RFID reader Start charging 1. Use your charging cable to connect the EV-Box station to your vehicle. Present your charging card (RFID Card) to the card reader. The charging station will react with a tone. This indicates your card is being validated. It’s possible that the LED ring will flash yellow for a couple of seconds. -
Page 6: Led Ring Indicator
LED ring indicator The socket is surrounded by an LED ring. It shows the status of the charging station, so that you can see which mode the charging station is in (see Chapter 8). A blinking yellow LED-ring (once every second) indicates a paused charging session. This is only possible in a Hub-Satellite configuration (see chapter 6). -
Page 7: Installation
4. Installation Safety requirements Connecting and installing the charging station must be done by a qualified technician. The owner or user is responsible for the installation, operation and maintenance of the charging station, whereby both the law regarding the safety of persons, animals and property must be observed, as well as the installation instructions in force in the country of use. -
Page 8: Power Supply Cable
enters through the bottom of the pole. The other option is to mount it onto a sturdy wall between 90cm and 120cm from ground level. The supply line is fed through a cable gland at the lower side of the aluminium base plate or the hole on the back side of the base plate. The wall must be able to bear a load of 40kg. -
Page 9: Wall Mounting Bracket
In the ground: To install the pole itself dig in the pole to 60cm below ground level and align vertically (Figure 5). Ensure that the holes for securing the charging station are in the correct position with respect to the relevant parking place(s). The pole is provided with anchor blades of 300 mm x 300 mm. -
Page 10: Finishing Installation
6. Holes have been pre-drilled in the pole to attach the charging station by means of the M6 bolt supplied. 7. Connect the pole to the ground with the ground cable and the M6 bolt + washer supplied to the lowermost tube terminal. (Figure 5). 8. -
Page 11: Maintenance
Maintenance Dirt on the outside of the charging station can be cleaned off using a damp soft cloth. The owner or user is responsible for the maintenance of the charging station, whereby both the law regarding the safety of persons, animals and property (in NL NEN 3140) must be observed, as well as the installation instructions in force in the country of use. -
Page 12: Installing The Modem Externally
5. Installing the modem externally A GSM link with the charging station is essential for the charging station to function properly. However, a good link cannot always be obtained in enclosed spaces, for instance a closed or underground car park. In cases like this, the modem can be positioned outside the charging station along with the GSM/GPS antenna and connected to the charging station. -
Page 13: Adding Extra Connectors (Satellites)
6. Adding extra connectors (Satellites) Several charging stations without a modem (Satellites) can be linked to a charging station with a modem in a hub / satellite connection thus forming a grid. The grid can support up to a total of 20 sockets. The advantages are that control of the charging stations is simpler and that, for locations with a poor GSM link, only a single modem has to be installed externally. -
Page 14: Technical Specifications
7. Technical Specifications These are general specifications for the BusinessLine. You can find more details about the technical specifications in the “Downloads” section of EV-Box.com. Item Description 1-phase or 3-phase, 50Hz, between 2.5 – 10mm2 Connection capacity Output power per connector 1-phase or 3-phase, 230V –... -
Page 15: Troubleshooting
8. Troubleshooting EV-Box highly recommends the installation work to be done by a qualified electrician and or installation partner. Problem Possible cause Solution Charging station does not react No power to charging station Are the residual current device • • and circuit breaker in the meter cabinet on? ( check by user) Is main switch in the charging... - Page 16 Problem Possible cause Solution LED ring continues to light up Charging station waiting for Are the plugs properly inserted • • yellow the vehicle in the vehicle and charging Vehicle is fully charged station? ( check by user) • Grounding resistance correct? Faulty charging cable •...
-
Page 17: Eu Declaration Of Conformity
9. EU Declaration of Conformity MANUFACTURER'S DECLARATION (in accordance with Appendix II-B of the Machinery Directive) EV-Box B.V., Pedro de Medinalaan 31, 1086XP Amsterdam, The Netherlands, declares under sole responsibility that the product: Article B116X-XXXX: EV-Box Charging station 1-phase 16A Article B132X-XXXX: EV-Box Charging station, 1-phase 32A Article B316X-XXXX: EV-Box Charging station, 3-phase 16A Article B332X-XXXX: EV-Box Charging station, 3-phase 32A...
Need help?
Do you have a question about the BusinessLine series and is the answer not in the manual?
Questions and answers