Advertisement
Quick Links
Advertisement
Related Manuals for Soaring USA Stobel V2
Summary of Contents for Soaring USA Stobel V2
- Page 1 ...
- Page 2 Instructions - Stobel Congratulations on the purchase of your Stobel, a high end DLG-competition model from LE-composites. We hope you will be happy and successful. To ensure the optimum build we ask you if possible to follow in accordance with instructions and work towards the completion carefully and accurately. Read the Instructions carefully and build in the recommended order.
- Page 3 Completion of the Elevator and Rudder The tail feathers of Stobel V2 are a high quality prefabrication. The springs provided (see diagram below) are designed to optimize precise control of the tail feathers via the supplied control horns. This type of linkage has been 100% proven and should be installed as illustrated and described.
- Page 4 Fold the rudder over as much as possible and twist the wire until you put it in the tail (per diagram below) The spring force of the wire should now press the moveable part permanently to the outside ...
- Page 5 Completion of the Fuz First, the positions of the RC equipment need to be identified. A battery comprising 4x GP350 Cells, or 350Mah lipo and a 2x D47 servos, about 10g heavy receiver should be suitable to ensure the CG is approximately right.
- Page 6 Secure the rod with a little 5 min epoxy on the formers and position the ballast system in addition to the fuselage. The bulkhead is then glued so the rear bulkhead is located directly below the end of the nose bar and the notch in the ballast bar is directly under the wing surface screw.
- Page 7 Now the Kevlar cord for the pull system can be installed. A small cutout on the side elevator pylon is necessary for the cord sleeves. Oops! Run the cables never without sleeves outwards. You can tear through the carbon boom very easily. ...
- Page 8 For the antenna use a 25cm long piece of 0.3 mm steel wire. This can be glued well insulated at the end of the rudder . The connection to the receiver can be by solder or connector of choice. ...
Need help?
Do you have a question about the Stobel V2 and is the answer not in the manual?
Questions and answers