Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Dolphin X 40 PLUS
Summary of Contents for Dolphin X 40 PLUS
- Page 1 Robotic Pool Cleaner Dolphin X40 PLUS 8151662-AU Ver. 01 09/2017...
-
Page 3: Table Of Contents
Dolphin X 40 PLUS User Instructions Contents 1. INTRODUCTION ..............2 2. SPECIFICATIONS ..............2 3. WARNINGS AND CAUTIONS ..........2 3.1 Warnings ................2 3.2 Cautions ................2 4. POOL CLEANER PARTS ............3 5. USING THE POOL CLEANER ........... 4 5.1 Setup .................. -
Page 4: Introduction
• Do not enter the pool while the Pool Cleaner is working • Unplug the power supply before servicing 3.2 Cautions Use the Pool Cleaner in the following water conditions only: Chlorine Maximum 4 ppm 7.0-7.8 Temperature 6-34°C / 43-93°F NaCl Maximum 5000 ppm Dolphin X 40 PLUS| User Instructions... -
Page 5: Pool Cleaner Parts
4. POOL CLEANER PARTS Robotic Pool Cleaner Power supply unit Filtration Caddy kit Dolphin X 40 PLUS| User Instructions... -
Page 6: Using The Pool Cleaner
Plug in the power supply and leave it in the supply by inserting it with the notch on the OFF position. connector (1), lined up with the groove in the socket on the power supply, and turning clockwise (2). Dolphin X 40 PLUS| User Instructions... -
Page 7: Putting The Pool Cleaner Into The Pool
Release the Pool Cleaner and let it sink to the floor The Pool Cleaner will now operate until it has of the pool. reached the end of the cleaning cycle. Make sure that the floating cable is free of any obstructions. Dolphin X 40 PLUS| User Instructions... -
Page 8: Removing The Pool Cleaner From The Pool
Using the handle, remove the Pool Cleaner from the pool. DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE. CAUTION 5.3.3 Place the Pool Cleaner on the edge of the pool and let the water drain out. Dolphin X 40 PLUS| User Instructions... -
Page 9: Cleaning The Dual Filter Basket
Upon opening the filter cover, the handle will lift independently. 6.1.3 Lift up the basket. 6.1.4 Open the latch 6.1.5 Clean the filter basket to release the bottom lid with a hose. in order to remove the debris. Dolphin X 40 PLUS| User Instructions... -
Page 10: Periodic Filter Cleaning
Clean the filter panels with a hose. 6.2.5 Assemble the filter panels according to the following order: Panel 4 — > 3 — > 2 — > 1. 6.2.6 Insert the clean filter basket and close the filter cover. Dolphin X 40 PLUS| User Instructions... -
Page 11: Cleaning The Impeller
7.1 If you notice debris trapped in the impeller: Make sure the power supply is switched off and unplugged. CAUTION Clean the debris trapped in the impeller opening, according to the following steps: 7.1.1 7.1.2 7.1.3 7.1.4 Dolphin X 40 PLUS| User Instructions... -
Page 12: Off-Season Storage
• Roll up the cable so that it has no kinks • Store the Pool Cleaner in a protected area out of direct sun / rain / frost, at a temperature of between 5°-45°C / 41°-113°F Dolphin X 40 PLUS| User Instructions... -
Page 13: Troubleshooting
If so, adjust the levels and scrub the walls. • Debris stuck in the impeller-house • Remove debris stuck in the impeller-house or impeller-cover or impeller-cover. (drawings 7.2.1 & 7.2.2). Dolphin X 40 PLUS| User Instructions... - Page 14 Dolphin X40 PLUS 8151662-AU Ver. 01 09/2017 www.maytronics.com...
Need help?
Do you have a question about the X 40 PLUS and is the answer not in the manual?
Questions and answers