Fault Reset; Electronics Temperature; Condensed Status - Siemens Sitrans LR250 Operating Instructions Manual

3.3. Fault Reset

Clears the following faults:
Fault Code
S3
S4
S6
S7
S8
S9
S12
S17
S18
To clear a fault using the handheld programmer:
• Enter the fault code number then press RIGHT arrow.
To clear a fault via SIMATIC PDM:
• Open the menu Device – Acknowledge Faults.
• Select the fault to be cleared from the pull-down menu in Extended
Diagnostics.
• Click on Transfer to clear the fault.

3.4. Electronics Temperature

3.4.1. Minimum Value
The minimum recorded internal electronics temperature of the SITRANS LR250.
3.4.2. Maximum Value
The maximum recorded internal electronics temperature of the SITRANS
LR250.

3.5. Condensed Status

When Enable (3.5.1.) is enabled, you can select the level of severity of errors, and
tailor a device response appropriate for your particular process.
• In Event Index (3.6.1.) you can select a particular event or error by means of its
index number.
• In Event Status (3.6.2.) you can assign a status to the selected event.
• In Event Diagnosis (3.6.3.) you can assign a diagnosis to the selected event.
Page 88 SITRANS LR250 (PROFIBUS PA) – OPERATING INSTRUCTIONS
Device Lifetime Reminder 1 (Maintenance Required)
Device Lifetime Reminder 2 (Maintenance Demanded)
Sensor Lifetime Reminder 1 (Maintenance Required)
Sensor Lifetime Reminder 2 (Maintenance Demanded)
Device Service Reminder 1 (Maintenance Required)
Device Service Reminder 2 (Maintenance Demanded)
Internal Temperature High
Calibration Schedule Reminder 1 (Maintenance
Required)
Calibration Schedule Reminder 2 (Maintenance
Demanded)
Description
7ML19985JF04