Plugging In The Scanner - Epson 1680 Manual

2. Slide the transportation lock lever on the back of the scanner to the UNLOCK
position, as shown below.
Note:
Simply sliding the transportation lock to the LOCK position does not fully lock the
carriage. Before moving or transporting the scanner, be sure to perform the procedure
under "Transporting the Scanner and the Transparency Unit" in the online Reference
Guide.

Plugging in the scanner

1. Make sure that the scanner is turned off. The scanner is off when the
button is raised (not depressed).
2. If the power cord is not attached to the scanner, connect it to the AC inlet on the
back of the scanner, and plug the other end into a properly grounded electrical outlet.
c
Caution:
It is not possible to change the scanner's voltage. If the label on the back of
the scanner does not show the correct voltage for your country, contact your
dealer. Do not plug in the power cord.
P
operate
13