System Maintenance Switch - HP ProLiant ML110 G7 Maintenance And Service Manual

Install the DIMM.
6.
Install the access panel
7.
Lock the tower bezel.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server.
11.

System maintenance switch

Position
1
2
3
4
5
6
7
8
9
10
When the system maintenance switch position 6 is set to the On position, the system is prepared to erase all
system configuration settings from both CMOS and NVRAM.
CAUTION:
properly configure the server or data loss could occur.
("Installing the access
Default Function
Off Off = iLO 3 security is enabled
On = iLO 3 security is disabled
Off Off = System configuration can be
changed
On = System configuration is locked
— Reserved
— Reserved
Off Off = Power-on password is enabled
On = Power-on password is disabled
Off Off = No function
On = Clear NVRAM
— Reserved
— Reserved
— Reserved
— Reserved
Clearing CMOS and/or NVRAM deletes configuration information. Be sure to
panel" on page 24).
Removal and replacement procedures 63