Configuring Anqp Ip Address Availability Profiles - Alcatel-Lucent AOS-W 6.5.3.x User Manual

In the CLI
To configure an ANQP domain name profile from the switch CLI, access the CLI in config mode and issue the
following commands:
wlan hotspot anqp-domain-name-profile <profile-name>
clone <profile-name>
domain-name <domain-name>
no ...
Configuring ANQP IP Address Availability Profiles
Use this profile to specify the types of IPv4 and IPv6 IP addresses available in the hotspot network. This
information is sent in an Access network Query Protocol (ANQP) information element in a Generic
Advertisement Service (GAS) query response.
To send the values configured in this profile to clients, you must associate this profile with an advertisement
profile, then associate the advertisement profile with a hotspot 2.0 profile. For details, see
Advertisement Profiles on page
In the WebUI
To configure an ANQP IP address availability profile from the switch WebUI:
1. Navigate to Configuration>Advanced Services>All Profiles.
2. In the profiles list, expand the Wireless LAN section.
3. Select ANQP IP Address Availability
4. Select an existing profile from the list of profiles on the profile details pane or create a new profile by
entering a profile name into the entry blank, then clicking Add.
5. Configure the following parameters as desired, then click Apply to save your settings.
905| 802.11u Hotspots
899.
Configuring Hotspot
AOS-W 6.5.3.x | User Guide