Page 3
5. Recovery Tank Model Number: 1231845 6. Scrub Deck FUNCTION The i-mop XL is an autoscrubber which is used for cleaning hard floors. A working width of 18.1” and the nearly unrestricted pivot technology enable an effective cleaning of small or medium spaces.
Page 6
WARNING FIRST AID MEASURES If exposed to any of the battery chemicals, please follow the procedures below: Eyes - Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelid. - Seek medical attention. Inhalation - Vacate from site of exposure to fresh air immediately, use oxygen if available.
Page 7
Please make sure no items are missing by checking the contents against the below list. If one of the parts listed is missing, please contact your i-mop dealer. 1 x Battery 1 x Power Pack (left) Cord #1232544 #1232546 1 x i-mop XL #1231845 1 x Battery 1 x Squeegee Pack (right) #1232588 #1232596 1 x Solution...
Page 8
INITIAL SETUP Set the i-mop in the “Park” position. For the initial setup or anytime the squeegee is not installed: pull the hose back up from the top while guiding the lower half back into the i-mop to make sure the vacuum hose will not be crimped during the following procedure.
Page 9
CHARGING BATTERY PACKS You must charge the battery packs for at least 5 hours before you use the i-mop for the time. Plug the supplied power cord into the charging dock before plugging it into an outlet. Align the battery packs with the charging dock and slide each battery pack in from the side until you hear a click.
Page 13
Selecting the Mode of Operation Choose the preferred mode on the i-mop operating panel: MODE 1: Brush + Water/Solution MODE 2: Brush (use the Brush only mode if the is very wet or to scrub stains) MODE 3: Brush + Dry Vacuum MODE 4: Brush + Water/Solution + Dry Vacuum ECO (Water Saving Mode) If you press the ECO water saving mode button once, the i-mop will use 40% less water until the ECO mode...
Page 19
DECLARATIONS UL Declaration We hereby declare that this i-mop XL complies with the relevant basic safety and health requirements of UL standard, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is without our prior approval.
EXPLODED VIEW ITEM TENNANT P/N DESCRIPTION ASSEMBLY TOP UNIT 1232438 ASSEMBLY CONTROL UNIT 1232443 ASSEMBLY INLET TUBE 1232694 HINGE WELDING ASSEMBLY TOP UNIT KIT 1232674 VACUUM MOTOR KIT 1232711 MOTOR UNIT COVER KIT 1232494 UTP CABLE RJ 45 L 100 CM 1232514 ASSEMBLY CLEAN COMPARTMENT COMPLETE 1232544...
Need help?
Do you have a question about the i-mop XL and is the answer not in the manual?
Questions and answers