Calibration And Firmware Upgrade - Zhiyun CRANE 2 User Manual

Calibration and Firmware Upgrade

When do you need to calibrate the stabilizer?
Please calibrate the stabilizer when necessary to ensure normal use.
When
a) Slight deviation is found in the tilt angle of the camera in level position after
startup.
b)


Slight deviation is found in the roll angle of the camera in level position after
startup.
c)


Frequent small angle correction is found when the camera is in level position
while the stabilizer stays still.
a) Slight deviation is still found in level position after the initialization of the
stabilizer.
b)


Stabilizer unused for a long time.
c)


Too large temperature difference between operation environments.
Slight deviation is still found in the tilt or roll angle of the camera in level
position after the initialization and six-side calibration of the stabilizer.
Initialization Method
1.Correctly install the batteries.
2.Hold the camera mounting plate with one hand, long press the power button to start up
the stabilizer ; Long press the Mode button to enter the standby mode while holding the
camera mounting plate through the whole process in case of start-up failure.
If the angle deviation still persists after the initialization, please tr y again following the
procedure.
25 zhiyun-tech.com
Six-side calibration
How
1. Power on the stabilizer and enter the standby mode, press menu, rotate the dial to
"calibration" option, press Right to enter the option.
Initialize the
2. As seen below, conduct the six-side calibration following the 6 steps shown in the graphs,
stabilizer
finish by pressing any button to exit the menu.
Conduct six-side
calibration
Fine tune motor
force
Calibration and Firmware Upgrade
Six-side Calibration
STEP 1
STEP 2
STEP 3
zhiyun-tech.com 26