Alcatel-Lucent 7450 Configuration Manual page 225

Default No interfaces are configured by default.
Parameters
ip-int-name — Specify the interface name. If the string contains special characters (#, $, spaces,
current-hop-limit
Syntax current-hop-limit number
no current-hop-limit
Context config>router>router-advert>if
Description This command configures the current-hop-limit in the router advertisement messages. It informs the
nodes on the subnet about the hop-limit when originating IPv6 packets.
Default 64
Parameters number — Specifies the hop limit.
managed-configuration
Syntax [no] managed-configuration
Context config>router>router-advert>if
Description This command sets the managed address configuration flag. This flag indicates that DHCPv6 is
available for address configuration in addition to any address autoconfigured using stateless address
autoconfiguration. See RFC 3315, Dynamic Host Configuration Protocol (DHCP) for IPv6.
Default no managed-configuration
max-advertisement-interval
Syntax [no] max-advertisement-interval seconds
Context config>router>router-advert>if
Description This command configures the maximum interval between sending router advertisement messages.
Default
600
Parameters
seconds — Specifies the maximum interval in seconds between sending router advertisement
Router Configuration Guide
etc.), the entire string must be enclosed within double quotes.
Values
0 to 255. A value of zero means there is an unspecified number of
hops.
messages.
Values
4 to 1800
IP Router Configuration
225