Throttle Body Removal - Honda MUV700 big red Service Manual

THROTTLE BODY
REMOVAL
NOTE.
• If the TP sensor/MAP sensor (sensor unit) is
removed from the throttle body, the TP sensor
reset procedure must be performed after install-
ing the throttle body (page 6-52),
Relieve the fuel pressure (page 6-31).
Remove the air cleaner housing (page 6-41).
Disconnect the following:
- injector 2P gray connector
- IACV 4P black connector
- sensor unit
5P
black connector
Remove the wire clip from the hose guide bracket.
Disconnect the quick connect fitting from the fuel
injector (page 6-31).
Remove the screw/washer and throttle drum cover.
Loosen the throttle cable adjuster lock nut, remove
the adjuster from the throttle body and disconnect
the cable end from the throttle drum.
loosen the insulator band screw and remove the
throttle body from the insulator.
FUEL SYSTEM (PGM -FI)
6-45