Cisco ISA550 Administration Manual page 8

Getting Started
Getting Started with the Configuration Utility
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco ISA500 Series Integrated Security Appliances Administration Guide
Logging in to the Configuration Utility
Connect your computer to an available LAN port on the back panel.
Your PC will become a DHCP client of the security appliance and will receive an IP
address in the 192.168.75.x range.
Start a web browser. In the address bar, enter the default IP address of the
security appliance: 192.168.75.1.
NOTE: The above address is the factory default LAN address. If you change this
setting, enter the new IP address to connect to the Configuration Utility.
When the login page opens, enter the username and password.
The default username is cisco. The default password is cisco. Usernames and
passwords are case sensitive.
Click Login.
For security purposes, you must change the default password of the default
administrator account. Set a new administrator password and click OK.
If you can access the Internet and a newer firmware is detected, the Firmware
Upgrade window opens. Follow the on-screen prompts to download and install
the firmware. See Upgrading your Firmware After your First Login, page
If you cannot access the Internet or you are using the latest firmware, the Setup
Wizard will now launch. Follow the on-screen prompts to complete the initial
configuration. See Using the Setup Wizard for the Initial Configuration, page
1
33.
36.
26