Pw-Class Encapsulation Mpls - Cisco ASR 9000 Series Reference Manual

pw-class encapsulation mpls

pw-class encapsulation mpls

To configure MPLS pseudowire encapsulation, use the pw-class encapsulation mpls command in L2VPN
pseudowire class configuration mode. To undo the configuration, use the no form of this command.
pw-class class-name encapsulation mpls {control word| ipv4| load-balancing flow-label| preferred-path|
protocol ldp| redundancy one-way| sequencing| switching tlv| tag-rewrite| transport-mode| vccv
verification-type none}
no pw-class class-name encapsulation mpls {control word| ipv4| load-balancing flow-label| preferred-path|
protocol ldp| redundancy one-way| sequencing| switching tlv| tag-rewrite| transport-mode| vccv
verification-type none}
Syntax Description
class-name
control word
ipv4
load-balancing flow-label
preferred-path
protocol ldp
redundancy one-way
sequencing
switching tlv
tag-rewrite
transport-mode
vccv none
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
128
Point to Point Layer 2 Services Commands
Encapsulation class name.
Disables control word for MPLS
encapsulation. Disabled by default.
Sets the local source IPv4 address.
Sets flow label-based load
balancing.
Configures the preferred path
tunnel settings.
Configures LDP as the signaling
protocol for this pseudowire class.
Configures one-way PW
redundancy behavior in the
Redundancy Group.
Configures sequencing on receive
or transmit.
Configures switching TLV to be
hidden or not.
Configures VLAN tag rewrite.
Configures transport mode to be
either Ethernet or VLAN.
Enables or disables the VCCV
verification type.