Advertisement
Quick Links
Filter Installation Instructions
Figure 1
Filter
head
Neck
Filter cap
Filter body
Operating conditions
Maximum working pressure: 6 bar (90psi) - see note* on page 4
Maximum working temperature: 30°C (86°F)
Minimum working pressure: 1.4 bar (20psi)
Minimum working temperature: 5ºC (41ºF)
Maximum plastic housing life: 10 years - see note* on page 4
PLEASE NOTE: Allowing the unit to freeze will invalidate the product
warranty
Important
1.
This filter is intended for installation under the sink away from direct sunlight
2.
This filter is not designed for the treatment of hot water and should only be
connected to the cold water supply
3.
It is important to wear rubber gloves or wash your hands thoroughly before
Filter element
and after servicing the filter
mount
4.
Care must be taken at all times to prevent contamination of the neck of the
filter cap and stem of the filter element mount by contact with unfiltered
water or dirty hands after cleaning the filter element surface
Connecting Pipework and Fittings for either the 1/4" or 3/8" models:
The filter is supplied with pushfit connections. Medium density polyethylene tubing
from a reputable supplier is recommended. An isolation valve and non-return valve
should be fitted upstream of the filter (these are required by law in the UK).
The isolation valve may be used to regulate the maximum flow rate in
accordance with the requirement of the filter element used. Having selected the
appropriate fittings, a user valve/faucet should be installed in accordance with
the manufacturer's instructions in a convenient position and then connected
downstream of the filter.
www.doulton.com
A GENUINE
WATER FILTER
A GENUINE WATER FILTER
Advertisement
Related Manuals for Doulton EcoFast
Summary of Contents for Doulton EcoFast
-
Page 1: Operating Conditions
Having selected the appropriate fittings, a user valve/faucet should be installed in accordance with the manufacturer’s instructions in a convenient position and then connected downstream of the filter. A GENUINE WATER FILTER A GENUINE WATER FILTER www.doulton.com... - Page 2 Detailed guide to fitting the filter element - figures 2, 3, 4 & 5 Figure 2 Locate the filter in an upright position near to the incoming cold water supply and the user tap/faucet. Filter Head Ensure that the connecting pipework will not have any sharp bends in it and allow at least Filter Cap 100mm (4”) of clearance below the assembled filter for removal of the cartridge to service or replace - see figure 2.
- Page 3 Press gently onto the candle surface with the kitchen pad, whilst quickly turning the element with the other hand. Applying a gentle even pressure with the scouring pad slowly work down the length of the filter element once, ensuring that the cleaning is uniform over the whole candle - see figure 9. www.doulton.com...
- Page 4 Contact your local dealer/agent. Product warranty Your EcoFast filter housing is covered under warranty for 12 months from the purchase date of the product against any failure due to defect of materials, workmanship or design of the filter housing. Please retain your receipt as proof of purchase.
Need help?
Do you have a question about the EcoFast and is the answer not in the manual?
Questions and answers