Camera Preparation And Installation - Aquatica Digital AD500 Instruction Manual

Care and maintenance, O-rings section (page 22).
STEP 5: Insert the provided CR 2032 coin cell battery in the Surveyor alarm. Read
Accessories, Surveyor sensor (page 16) for more details on sensor
operation.

Camera preparation and installation

Follow these steps to prepare your Nikon D500 camera for use with your housing. It is
also advisable before inserting the camera into the housing, in order to save valuable
time underwater, to set your camera shooting preferences beforehand.
STEP 1: Remove the quick release tray
from the housing by pressing
down on the lever and then
pulling the tray out.
STEP 2: Lift the camera's LCD screen out
of the way and carefully place the
camera on the tray. Make sure
that
aligned with the pin and the
stoppers on the tray then tighten
the mounting screw. Finally lower
the LCD screen so that it rests on
the two rear stoppers at an angle.
STEP 3: [IMPORTANT]
the housing, pull out the Lens Release (43), AF/M (44) and Zoom/ Focus
Knob (42) located on the left of the housing as well as the FN 1 Control
lever (15) located on the Right.
Camera preparation and installation
the camera is
To avoid any interference while inserting the camera in
properly
11 | AD500 INSTRUCTION MANUAL