Hard Drive Cable - HP ProBook 440 G5 Maintenance And Service Manual

Hard drive cable

Description
Hard drive cable (included in Hard Drive Hardware Kit)
Before removing the hard drive cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
5. Remove the battery
a. Service doors
b. Hard drive
c. Keyboard
d. Top cover
To remove the hard drive cable:
1. Position the computer upright on a flat surface and open the display as far as possible.
2. Disconnect the cable from the ZIF connector on the system board (1).
3. Remove the cable from the clip (2), and then route the cable through the hole and out the bottom of the
computer (3).
Reverse this procedure to install the hard drive cable.
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Battery on page 64), and then remove the following components:
(Service doors on page
(Hard drive on page 41)
(Keyboard on page 44)
(Top cover on page 48)
(Battery Safe mode on page
33).
Spare part number
L01083-001
32).